smartctl -a output on crazy-unloading drives
Hello,
As the $SUBJ says, please post the result of "smartctl -a" on the affected drives for documentation and verification.
Thank you.
Signature · 1 line
tejun
A message that is not in the archive (sent off-list or not yet received): [email protected]
A message that is not in the archive (sent off-list or not yet received): [email protected]
A message that is not in the archive (sent off-list or not yet received): [email protected]
(restoring linux-ide cc)
Quoted 4 lines · Tobias Stegmann
Yes, I'm using the APM setting between 6 and 12 months now. If I'm using standard APM settings, the
Load_Cycle_Countsincreases very fast and there is this clicking noise I can hear.
I'm not quite sure, but I think its rated for over 1.500.000 LCCs.
Can you please turn off APM setting and see how much Load_Cycle_Counts increases in an hour under light usage?
Thanks.
Signature · 1 line
tejun
A message that is not in the archive (sent off-list or not yet received): [email protected]
Quoted 4 lines · Tobias Stegmann
The results:
1 hour surfing, hearing mp3 files: 24 Load Cycles
Then idling for a few minutes: ~5 LCCs/minute
5 cycles per minute. Impressive even w/ 1.5mil rate. Thanks for testing.
Signature · 1 line
tejun
Quoted 5 lines · Tejun Heo
Hello,
As the $SUBJ says, please post the result of "smartctl -a" on the affected drives for documentation and verification.
Attached. It should be noted that this machine has been running with enforced disabled powersaving (by me) pretty much from day 1.
Kind Regards,
Ivan Zlatev
Quoted 9 lines · Ivan N. Zlatev
Quoted 5 lines · Tejun Heo
Hello,
As the $SUBJ says, please post the result of "smartctl -a" on the affected drives for documentation and verification.
Attached. It should be noted that this machine has been running with enforced disabled powersaving (by me) pretty much from day 1.
Can you please test how much the load cycle count increases on the default setting under light and idle load?
Thanks.
Signature · 1 line
tejun