What's needed for new cpu subdirectory?
For OMAP3 patch [1] I try to move common files currently in cpu/omap3 to cpu/arm_cortexa8/omap3 as discussed earlier [2].
Moving the files is easy, but how has main Makefile to be configured?
I have
Quoted 1 line
ls -a cpu/arm_cortexa8/
. .. omap3
Quoted 1 line
ls -a cpu/arm_cortexa8/omap3/
. board.c config.mk interrupts.c Makefile nand.c sys_info.c .. clock.c cpu.c lowlevel_init.S mem.c start.S syslib.c
and in main Makefile
@$(MKCONFIG) $(@:_config=) arm arm_cortexa8 omap3 evm omap3
This results in
make -C cpu/arm_cortexa8 start.o
which fails as start.S is in cpu/arm_cortexa8/omap3/
Any hint what is necessary to get stuff in cpu/arm_cortexa8/omap3/ compiled?
Thanks
Dirk
[1] http://lists.denx.de/pipermail/u-boot/2008-September/040561.html
[2] http://lists.denx.de/pipermail/u-boot/2008-September/040712.html
Dear Dirk,
Quoted 3 lines · In message <[email protected]> you wrote:
For OMAP3 patch [1] I try to move common files currently in cpu/omap3 to cpu/arm_cortexa8/omap3 as discussed earlier [2].
Ummm... if it's common files - shouldn't these go to cpu/arm_cortexa8/ then, and cpu/arm_cortexa8/omap3/ would have only OMAP3 specific files?
Best regards,
Wolfgang Denk
Signature · 6 lines
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de Randal said it would be tough to do in sed. He didn't say he didn't understand sed. Randal understands sed quite well. Which is why he uses Perl. :-) - Larry Wall in <[email protected]>