iptables install

I'm trying to build iptables-1.4.2 for a 2.6 kernel running on an embedded ARM device (up to now I've used 1.2.11 on a 2.4 kernel). To build and install, I run:

#./configure --host=arm --enable-static KERNEL_DIR=$KERNEL_SOURCE prefix=$BUILD_DIR CC=arm-9tdmi-linux-gnu-gcc LD=arm-9tdmi-linux-gnu-ld AR=arm-9tdmi-linux-gnu-ar

#make KERNEL_DIR=$KERNEL_SOURCE prefix= CC=arm-9tdmi-linux-gnu-gcc LD=arm-9tdmi-linux-gnu-ld AR=arm-9tdmi-linux-gnu-ar

#make KERNEL_DIR=$KERNEL_SOURCE prefix=$BUILD_DIR CC=arm-9tdmi-linux-gnu-gcc LD=arm-9tdmi-linux-gnu-ld AR=arm-9tdmi-linux-gnu-ar install

In $BUILD_DIR/sbin , I then see "iptables-static". Is that the binary I should run? Or put another way, should I rename "iptables-static" to "iptables" to use the same scripts and apps that expect a binary called "iptables"? Why doesn't "make install" name it iptables? Or am I doing something wrong on the install side?

When I do rename it to "iptables", and I run iptables on the device, the output looks like it's still trying to load modules from somewhere, even though I used the --enable-static option when running configure. The output:

--------Output start

modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
modprobe: could not parse modules.dep
Chain INPUT (policy ACCEPT)

target     prot opt source               destination
REJECT     udp  --  anywhere             anywhere            udp

dpt:domain reject-with icmp-host-prohibited

Chain FORWARD (policy ACCEPT)
target prot opt source destination

Chain OUTPUT (policy ACCEPT)
target prot opt source destination

------------ Output end

What modules could it be attempting to load? Or should I disregard it and assume it's working? (It looks like it works after a few simple tests)

Regards,
Richard Barry