Doubts about the get_phy_id function.

Hi All,
Using a bad PHY address, the physical device is erroneously attached to the MAC device driver.
This happens because the get_phy_id function reads zero from the PHYIR1/2 regs and never fails.
I'm facing this problem on some PHY devices (*) but I've not clear enough if this can actually depend on an HW issue (e.g.invalid phy addresses have been left floating) or we need to apply the patch below. Indeed, it helps me to catch the problem and, as final result, the phy_connect always fails on wrong PHY address and the network interface cannot be opened.

(*) on other ones, the get_phy_id function reads 0xffff from PHYIR1/2 regs and fails (as expected results) when I try to attach a wrong PHY address.

Welcome advice.
Best Regards,
Peppe

PS: if it makes sense for you, I can rework the patch and send it to the ML again.

index 8ad602c..8a1baf9 100644
@@ -192,7 +192,7 @@ int get_phy_id(struct mii_bus *bus, int addr, u32 *phy_id)
        * in the upper half */
       phy_reg = bus->read(bus, addr, MII_PHYSID1);
 
-       if (phy_reg < 0)
+       if (phy_reg <= 0)
               return -EIO;
 
       *phy_id = (phy_reg & 0xffff) << 16;

@@ -200,7 +200,7 @@ int get_phy_id(struct mii_bus *bus, int addr, u32 *phy_id)
       /* Grab the bits from PHYIR2, and put them in the lower half */
       phy_reg = bus->read(bus, addr, MII_PHYSID2);
 
-       if (phy_reg < 0)
+       if (phy_reg <= 0)
               return -EIO;
 
       *phy_id |= (phy_reg & 0xffff);

Some people seem to have PHYs that report 0 as their ID, so that's not going to work. I'm pretty sure your bus needs to be floating high, so you might want to check that out.

Andy