Dvico Fusion Pro

Hi All, I have a Fusion Pro I'm testing with. Have installed the latest v4l-dvb drivers as per the wiki and the board is recognised correctly on boot and registers a /dev/dvb/adaptor0 device. However it is uable to tune anything - a "scan < au-Brisbane" runs with no errors, but finds no stations.

However if I install the pascoe drivers:
http://www.itee.uq.edu.au/~chrisp/Linux-DVB/DVICO/
http://linuxtv.org/hg/~pascoe/xc-test/

Its works fine - picks up the brisbane stations and displays them via mythtv

I thought the pascoe drivers were merged into the trunk ages ago - am I mistaken?

Thanks,

Lindsay

p.s My setup is a test PC and I can run tests as needed - doesn't matter if it breaks.

Lindsay
Softlog Systems



_______________________________________________
linux-dvb mailing list
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb

Lindsay,
I too seem to have an issue with tuning and DVICO drivers. Since I upgraded to mythbuntu 8.10 I have found my DViCO Dual Digital 4 has loaded proprly with no errors (thanks to the inclusion of xc... firmware), however no stations could be scanned with the firmware that came with it.

When I used the pascoe drivers in 8.04 I was able to tune stations.

Might this be related to the 7MHz issues in the past (with Australia having 7MHz channels)?

Cheers,
Damien.

_______________________________________________
linux-dvb mailing list
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb