mfd: Fix define values of CS1_HIB_MODE.

Hi Mark,

I found a little mistake.
The define values are wrong.

It is written in the WM8350 DATA SHEET Rev 3.4 P285 that CS1_HIB_MODE(bit 12) is disable at "1".

The following is it.

<WM8350 DATA SHEET Rev 3.4 P285>

REGISTER |BIT|    LABEL   | DESCRIPTION
ADDRESS  |   |            |
---------+---+------------+-------------
R172(ACh)| 12|CS1_HIB_MODE| 0=leave current sink as in Active
         |   |            | 1=disable current shik in Hibemate

Could you please check the following patch ?

Regards,
Naohiro Ooiwa

---
 include/linux/mfd/wm8350/pmic.h |    4 ++--
 1 files changed, 2 insertions(+), 2 deletions(-)

index 656279a..078363b 100644
@@ -83,8 +83,8 @@
 #define WM8350_CS1_ISEL_SHIFT                        0
 
 /* Bit values for R172 (0xAC) */
-#define WM8350_CS1_HIB_MODE_DISABLE                  0
-#define WM8350_CS1_HIB_MODE_LEAVE                    1
+#define WM8350_CS1_HIB_MODE_DISABLE                  1
+#define WM8350_CS1_HIB_MODE_LEAVE                    0
 
 #define WM8350_CS1_ISEL_220M                      0x3F
 

1.5.4.1

I will double check but I believe this to be a datasheet error - if it is it will be corrected in the datasheet.

Hi Mark,

I'm sorry for this late reply.

I checked the WM8350 DATA SHEET Rev 4.0 P287.
It's already corrected.

Thank you for your work.

Regards,
Naohiro Ooiwa

Mark Brown wrote::