Cinergy Hybrid XE with tm6010 chip

Hi,
I've got a Cinergy Hybrid XE DVB-T USB Stick, which has got a tm6010 chip inside (I opened the case just to get sure). Quite fast I realized, that there are no stable Linux drivers out there, so i tried the unstable one.

So I checked out the repo at http://linuxtv.org/hg/~mchehab/tm6010/ and compiled (without DVB), installed, loaded the module and then inserted the stick and well.. nothing happened, because the driver did not knew about my device. To fix this, i added the line
{ USB_DEVICE(0x0ccd, 0x0086), .driver_info = TM6010_BOARD_GENERIC }, to file tm6000-cards.c (my lsusb output is 'Bus 008 Device 004: ID 0ccd:0086 TerraTec Electronic GmbH'). I do not know, whether TM6010_BOARD_GENERIC is the correct one, but for me it seemed to be the best solution.
Afterward, the driver recognized my stick and began to work:
http://pastebin.com/f79722ed2 . In short: The firmware's missing. So I extracted the firmware with help of a python script I found on the internet and put it to the right place. Here's the (long) result:
http://pastebin.com/f6c853b43

I'm not surprised that my journey has failed, because I do not really know what my added line does (good old try'n'error), so my question:
Where to go from here?

Mark

_______________________________________________
linux-dvb mailing list
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb

Nobody?

_______________________________________________
linux-dvb mailing list
[email protected]
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb