ADS5121 how to use /dev/ttyPSC

Hi

I'm new to Kernel 2.6 and OF.

I'm using a ADS5121 board with kernel from denx (ads5121 branch from linux-2.6-denx). According to my dts file both PSC3 and PSC4 should be accessible through /dev/ttyPSC0 and /dev/ttyPSC1 respectively.

When I simply try to run: "$ echo "Hello" > /dev/ttyPSC*" I can't see any data coming out from the ports.
And when trying to initialize the ports using termios commands I'm getting the Error "Inappropriate ioctl for device".
I'm not even getting a negative voltage on the TX Pin (idle state). But I can see the driver ttyPSC with major 204 in /proc/devices and I can also open the device successfully. I am also able to configure either port as CONSOLE in U-Boot so the Hardware is ok.

Any ideas?
Many thanks,
Stefan

Are you sending it to just one of them at a time and just abbreviating your mail here to include both with a *, or are you really putting that asterisk in there when you test?

You're doing this manually or with an application?

So you're getting debug output (udbg type stuff) on them?

-- Matt Sealey