is uImage.FIT supported in U-boot 2008.10
I am unable to find the mkimage tool that takes the -f vmlinux.bin.gz argument. I am using ELDK4.2 compiling U-Boot 2008.10 using ARCH=powerpc for a MPC8548 board.
is the uImage.FIT currently supported, if so, where can i find the tools mentions in /u-boot/doc/uImage.FIT/howto.txt
thanks pieter
Dear Pieter,
Quoted 3 lines · In message <[email protected]> you wrote:
I am unable to find the mkimage tool that takes the -f vmlinux.bin.gz argument. I am using ELDK4.2 compiling U-Boot 2008.10 using ARCH=powerpc for a MPC8548 board.
What about tools/mkimage ?
Quoted 2 lines
is the uImage.FIT currently supported, if so, where can i find the tools mentions in /u-boot/doc/uImage.FIT/howto.txt
As far as U-Boot is concerned, you can find the tools in the tools/ directory. This, um, sounds pretty obvious to me. Or not?
Best regards,
Wolfgang Denk
Signature · 6 lines
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de : I've tried (in vi) "g/[a-z]\n[a-z]/s//_/"...but that doesn't : cut it. Any ideas? (I take it that it may be a two-pass sort of solution). In the first pass, install perl. :-) Larry Wall <[email protected]>