Skip to contentSkip to conversation

Change CONFIG_MG_DISK_RES unit to KB

PATCH New unsik Kim 2 participants 3 messages Feb 13, 2009 – Feb 17, 2009 Block layer

lore
Share & tools
lore

unsik Kim

author
#0 lore raw

PATCH 2/3 Change CONFIG_MG_DISK_RES unit to KB

Byte is too small unit for CONFIG_MG_DISK_RES and also needs sector size alignment.

---
 doc/README.mflash       |   10 +++++-----
 drivers/block/mg_disk.c |   10 +++-------
 2 files changed, 8 insertions(+), 12 deletions(-)
doc/README.mflash +5 -5
index fb74b90..d0d0f7b 100644
@@ -30,13 +30,13 @@ sector) and size of 0x400 (1024 byte)
 
 * Reserved size config (optional)
 If you want to use some reserved area for bootloader, environment variable or
-whatever, use CONFIG_MG_DISK_RES. The value should be multiple of
-MG_SECTOR_SIZE (512Byte). Mflash's block operation method use this value as
-start offset. So any u-boot's partition table parser and file system command
-work consistently. You can access this area by using mflash command.
+whatever, use CONFIG_MG_DISK_RES. The unit is KB. Mflash's block operation
+method use this value as start offset. So any u-boot's partition table parser
+and file system command work consistently. You can access this area by using
+mflash command.
 
 Following example sets 10MB of reserved area.
-#define CONFIG_MG_DISK_RES	10485760
+#define CONFIG_MG_DISK_RES	10240
 
 2-2. Porting mg_get_drv_data function
 Mflash is active device and need some gpio control for proper operation.
drivers/block/mg_disk.c +3 -7
index 4454fca..e1b1a68 100644
@@ -34,11 +34,7 @@
 #define CONFIG_MG_DISK_RES	0
 #endif
 
-#if (CONFIG_MG_DISK_RES % MG_SECTOR_SIZE != 0)
-#error "CONFIG_MG_DISK_RES should be MG_SECTOR_SIZE algined"
-#endif
-
-#define MG_DISK_RES ((CONFIG_MG_DISK_RES) / MG_SECTOR_SIZE)
+#define MG_RES_SEC ((CONFIG_MG_DISK_RES) << 1)
 
 #define MG_BASE	(host.drv_data->base)
 
@@ -344,7 +340,7 @@ unsigned int mg_disk_read_sects(void *buff, u32 sect_num, u32 sect_cnt)
 unsigned long mg_block_read (int dev, unsigned long start,
 		lbaint_t blkcnt, void *buffer)
 {
-	start += MG_DISK_RES;
+	start += MG_RES_SEC;
 	if (! mg_disk_read_sects(buffer, start, blkcnt))
 		return blkcnt;
 	else
@@ -482,7 +478,7 @@ unsigned int mg_disk_write_sects(void *buff, u32 sect_num, u32 sect_cnt)
 unsigned long mg_block_write (int dev, unsigned long start,
 		lbaint_t blkcnt, const void *buffer)
 {
-	start += MG_DISK_RES;
+	start += MG_RES_SEC;
 	if (!mg_disk_write_sects((void *)buffer, start, blkcnt))
 		return blkcnt;
 	else
Signature · 1 line
1.5.6.6
author
#2 lore raw

PATCH 2/3 Change CONFIG_MG_DISK_RES unit to KB

This series of patches are logically same as my previous mails. Wolfgang Denx requested splitting.
Please refer, <[email protected]>

Regards,
unsik Kim

Quoted 10 lines · Jean-Christophe PLAGNIOL-VILLARD
Quoted 4 lines · unsik Kim

Byte is too small unit for CONFIG_MG_DISK_RES and also needs sector size alignment.

why do you do this in an other patch?

Best Regards,
J.