Setup extra MIMC200 chip selects
PATCH v2 1/1 Setup extra MIMC200 chip selects
Added code to setup the extra Flash and FRAM chip selects as used on the MIMC200 board.
V2 moves the init code from the common "cpu.c" file into the board specific setup file.
Signed-off-by Mark Jackson <[email protected]>
--- board/mimc/mimc200/mimc200.c | 14 ++++++++++++++ 1 files changed, 14 insertions(+), 0 deletions(-)
board/mimc/mimc200/mimc200.c +14 -0
@@ -29,6 +29,8 @@#include <asm/arch/hmatrix.h> #include <lcd.h> +#include "../../../cpu/at32ap/hsmc3.h" +#define SM_PM_GCCTRL 0x0060DECLARE_GLOBAL_DATA_PTR ;
@@ -98,6 +100,18 @@ int board_early_init_f(void)/* release phys reset */ gpio_set_value (GPIO_PIN_PC18 ,0 );/* PHY RESET (Release) */ +/* setup Data Flash chip select (NCS2) */ +hsmc3_writel (MODE2 ,0x20121003 ); +hsmc3_writel (CYCLE2 ,0x000a0009 ); +hsmc3_writel (PULSE2 ,0x0a060806 ); +hsmc3_writel (SETUP2 ,0x00030102 ); + +/* setup FRAM chip select (NCS3) */ +hsmc3_writel (MODE3 ,0x10120001 ); +hsmc3_writel (CYCLE3 ,0x001e001d ); +hsmc3_writel (PULSE3 ,0x08040704 ); +hsmc3_writel (SETUP3 ,0x02050204 ); +#if defined(CONFIG_MACB )/* init macb0 pins */ gpio_select_periph_A (GPIO_PIN_PC3 ,0 );/* TXD0 */
Haavard Skinnemoen
AppliedPATCH v2 1/1 Setup extra MIMC200 chip selects
Quoted 7 lines · Mark Jackson
Added code to setup the extra Flash and FRAM chip selects as used on the MIMC200 board.
V2 moves the init code from the common "
cpu.c" file into the board specific setup file.Signed-off-by Mark Jackson <[email protected]>
Applied to mimc200 after fixing up some whitespace damage, thanks.
board/mimc/mimc200/mimc200.c line 32
Quoted 13 lines
--- board/mimc/mimc200/mimc200.c | 14 ++++++++++++++ 1 files changed, 14 insertions(+), 0 deletions(-)board/mimc/mimc200/mimc200.c +1
-0@@ -29,6 +29,8 @@#include <asm/arch/hmatrix.h> #include <lcd.h> +#include "../../../cpu/at32ap/hsmc3.h"
it would probably be better if this file was moved somewhere under include/asm-avr32, however.
Haavard