Skip to contentSkip to conversation

2.6.29 - raid10 issue - spares do not get synched automatically

DISCUSSION Patrick Ringl 2 participants 2 messages Mar 28, 2009 – Mar 29, 2009

lore
Share & tools
lore
#0 lore raw

Hello,

I am using 2.6.29 on a debian lenny. Anyway, I am having problems with a raid10 sandbox setup consisting of 4 loopback devices. To make a long story short:

I created a raid10 array with all these 4 devices (loop0-loop3)
then I set two devices faulty, removed them .. checked if I can still write to the array (which I could, so I/O errors, nothing in dmesg):

BUT - here it comes: once I am trying to (re)add them (I zero'ed the superblock before) they're only getting added as spares and the array will not sync.

Here's the logfile with mdadm -D /dev/md0 in between so one can see what is going on:

http://paste.debian.net/31758/

Any ideas?

PS: Please CC to me since I am not subscribed.

regards,
Patrick

#1 lore raw
Quoted 14 lines · Patrick Ringl

Hello,

I am using 2.6.29 on a debian lenny. Anyway, I am having problems with a raid10 sandbox setup consisting of 4 loopback devices. To make a long story short:

I created a raid10 array with all these 4 devices (loop0-loop3) then I set two devices faulty, removed them .. checked if I can still write to the array (which I could, so I/O errors, nothing in dmesg):

BUT - here it comes: once I am trying to (re)add them (I zero'ed the superblock before) they're only getting added as spares and the array will not sync.

Quoted 7 lines

Here's the logfile with mdadm -D /dev/md0 in between so one can see what is going on:

http://paste.debian.net/31758/

Any ideas?

You failed the whole array. With 4 devices in the default layout the array looks like stripe(mirror(slot0, slot1), mirror(slot2, slot3)). In your case mdadm -D shows that you have the loop devices in the following slots stripe(mirror(loop2, loop0), mirror(loop1, 3)). A raid10 is failed once all devices in a mirror set are failed, and a failed array can't be rebuilt.

Regards,
Dan