Skip to contentSkip to conversation

Marvell 88F6281 Reference design

DISCUSSION Eddie Dawydiuk 2 participants 2 messages Apr 28, 2009

lore
Share & tools
lore
#1 lore raw
In reply to Eddie Dawydiuk
Quoted 1 line · Eddie Dawydiuk

Hello,

Hi,

Quoted 10 lines

I have a Marvell 88F6281 Reference design board I'm trying to compile a 2.6.28 kernel for. Although, the machine id check is failing. The error is as follows

Uncompressing Linux............................................................................................................................. . done, booting the kernel.

Error: unrecognized/unsupported machine ID (r1 = 0x0000020f).

Quoted 8 lines

Available machine support:

ID (hex)        NAME
00000690        Marvell DB-88F6281-BP Development Board
00000691        Marvell RD-88F6192-NAS Development Board
00000692        Marvell RD-88F6281 Reference Board

Please check your kernel config and/or bootloader.

This is because the boot loader passes in the wrong machine ID.

If you have the u-boot "arcNumber" parameter, try setting that to the correct machine ID before booting the kernel. Otherwise, you can prepend a bit of code to the zImage that sets the machine ID to the right value, e.g. for the 6281 RD:

	(echo -en "\x06\x1c\xa0\xe3\x92\x10\x81\xe3"; cat zImage) > zImage.rd88f6281

and then use mkimage on zImage.rd88f6281 to create a uImage that you can boot on the board.

#0 lore raw

Hello,

I have a Marvell 88F6281 Reference design board I'm trying to compile a 2.6.28 kernel for. Although, the machine id check is failing. The error is as follows

Uncompressing Linux............................................................................................................................. . done, booting the kernel.

Error: unrecognized/unsupported machine ID (r1 = 0x0000020f).

Available machine support:

ID (hex)        NAME
00000690        Marvell DB-88F6281-BP Development Board
00000691        Marvell RD-88F6192-NAS Development Board
00000692        Marvell RD-88F6281 Reference Board

Please check your kernel config and/or bootloader.

I'm going to comment out this check temporarily(arch/arm/head.S), but wanted to notify you of this...

Please CC me personally with any responses.

Signature · 5 lines
Best Regards,
________________________________________________________________
 Eddie Dawydiuk, Technologic Systems | voice:  (480) 837-5200
 16525 East Laser Drive 	     | fax:    (480) 837-5300
 Fountain Hills, AZ 85268            | web: www.embeddedARM.com