Skip to contentSkip to conversation

about uboot leads to LAN disconnected

U-Boot wanghgsz 1 participant 1 message May 28, 2013

lore
Share & tools
lore

wanghgsz

author
#0 lore raw

Dear all,
Device is a camera connected LAN, camera board CPU is RT5350(based on MIPS) .
I have met a problem about uboot. uboot leads to LAN disconnected in the following cases. I have been looking forward to answers.
with best wishes

case 1 : when CRC checksum bad
Please choose the operation:
1: Load system code to SDRAM via TFTP.
2: Load system code then write to Flash via TFTP. 3: Boot system code via Flash (default).
4: Entr boot command line interface.
7: Load Boot Loader code then write to Flash via Serial. 9: Load Boot Loader code then write to Flash via TFTP.
0

3: System Boot system code via Flash.
## Booting image at bc050000 ...
raspi_read: from:50000 len:40
. Image Name: Linux Kernel Image

   Created:      2013-03-14   6:22:22 UTC
   Image Type:   MIPS Linux Kernel Image (lzma compressed)
   Data Size:    3113308 Bytes =  3 MB

Load Address: 80000000
Entry Point: 802fb000
raspi_read: from:50040 len:2f815c
................................................ Verifying Checksum ... Bad Data CRC

case 2 when modify parameters spend over 10 seconds

1: System Load Linux to SDRAM via TFTP.
Please Input new ones /or Ctrl-C to discard

        Input device IP (192.168.0.121) ==:192.168.0.121
        Input server IP (192.168.0.66) ==:192.168.0.66