Skip to contentSkip to conversation

myri10ge: drop myri10ge_lro module parameter

PATCH Applied Brice Goglin 2 participants 2 messages May 24, 2009 – May 25, 2009

Subsystems (2)
Networking Network drivers
lore
Share & tools
lore

Brice Goglin

author
#0 lore raw

PATCH 2/3 myri10ge: drop myri10ge_lro module parameter

Drop the myri10ge_lro module parameter now that we have ethtool to enable/disable LRO in the myri10ge driver.

Signed-off-by Brice Goglin <[email protected]>
---
 drivers/net/myri10ge/myri10ge.c |    7 +------
 1 files changed, 1 insertions(+), 6 deletions(-)
drivers/net/myri10ge/myri10ge.c +1 -6
index d317011..675f677 100644
@@ -327,10 +327,6 @@ static int myri10ge_debug = -1;	/* defaults above */
 module_param(myri10ge_debug, int, 0);
 MODULE_PARM_DESC(myri10ge_debug, "Debug level (0=none,...,16=all)");
 
-static int myri10ge_lro = 1;
-module_param(myri10ge_lro, int, S_IRUGO);
-MODULE_PARM_DESC(myri10ge_lro, "Enable large receive offload");
-
 static int myri10ge_lro_max_pkts = MYRI10GE_LRO_MAX_PKTS;
 module_param(myri10ge_lro_max_pkts, int, S_IRUGO);
 MODULE_PARM_DESC(myri10ge_lro_max_pkts,

@@ -3918,8 +3914,7 @@ static int myri10ge_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
 
 	if (dac_enabled)
 		netdev->features |= NETIF_F_HIGHDMA;
-	if (myri10ge_lro)
-		netdev->features |= NETIF_F_LRO;
+	netdev->features |= NETIF_F_LRO;
 
 	/* make sure we can get an irq, and that MSI can be
 	 * setup (if available).  Also ensure netdev->irq
Signature · 1 line
1.6.2.4