Problem with u-boot debugging
Hi!
I would like to port the U-Boot to a custom developed port with an Au1200 chip. I'm using the ELDK as toolchain.
I successfully compiled the U-Boot. I'm trying to debug it with a BDI-3000, through GDB. But anywhere I put a breakpoint (e.g. to the board_init_f), the program stops at line 234 in the start.s: mtc0 zero, CP0_WATCHLO, and it writes out:
Program received signal SIGABRT, Aborted.
reset () at start.S:234
234 mtc0 zero, CP0_WATCHLO
After I continue program running, the BDI writes out:
*** TARGET: all hardware breakpoints in use
and the gdb:
(gdb) c
Continuing.
Warning:
Cannot insert breakpoint 2.
Error accessing memory address 0xbfc01030: Unknown error 4294967295.
Contrarily, I can use the BDI's TI command, so from terminal, I can single step the program.
Any idea?
Here's the full gdb output:
(gdb) target remote bdi:2001
Remote debugging using bdi:2001_start () at start.S:64
64 RVECENT(reset,0) /* U-boot entry point */
(gdb) b board_init_f
Note: breakpoint 2 also set at pc 0xbfc01030. Breakpoint 3 at 0xbfc01030: file board.c, line 202. (gdb) c
Continuing.
Program received signal SIGABRT, Aborted.
reset () at start.S:234
234 mtc0 zero, CP0_WATCHLO
(gdb) c
Continuing.
Warning:
Cannot insert breakpoint -5.
Error accessing memory address 0xbfc00000: Ismeretlen hiba 4294967295.