Add nuvoton Ehci driver to usb tree
Subsystems (2)
Dear sirs,
According Eric's advice,I changed my patch,
Would you like to give me some advice again?
---
Add ehci support for w90p910 platform.
Signed-off-by Wan ZongShun <[email protected]>
--- drivers/usb/Kconfig | 2 + drivers/usb/host/Kconfig | 6 ++ drivers/usb/host/ehci-hcd.c | 5 + drivers/usb/host/ehci-w90x900.c | 181 +++++++++++++++++++++++++++++++++++++++ 4 files changed, 194 insertions(+), 0 deletions(-) create mode 100644 drivers/usb/host/ehci-w90x900.c
drivers/usb/Kconfig +2 -0
@@ -38,6 +38,7 @@ config USB_ARCH_HAS_OHCI default y if ARCH_AT91 default y if ARCH_PNX4008 && I2C default y if MFD_TC6393XB + default y if ARCH_W90X900 # PPC: default y if STB03xxx default y if PPC_MPC52xx
@@ -57,6 +58,7 @@ config USB_ARCH_HAS_EHCI default y if PPC_83xx default y if SOC_AU1200 default y if ARCH_IXP4XX + default y if ARCH_W90X900 default PCI # ARM SA1111 chips have a non-PCI based "OHCI-compatible" USB host interface.
drivers/usb/host/Kconfig +6 -0
@@ -93,6 +93,12 @@ config USB_EHCI_HCD_PPC_OF Enables support for the USB controller present on the PowerPC OpenFirmware platform bus. +config USB_W90X900_EHCI + bool "W90X900(W90P910) EHCI support" + depends on USB_EHCI_HCD && ARCH_W90X900 + ---help--- + Enables support for the W90X900 USB controller + config USB_OXU210HP_HCD tristate "OXU210HP HCD support" depends on USB
drivers/usb/host/ehci-hcd.c +5 -0
@@ -1072,6 +1072,11 @@ MODULE_LICENSE ("GPL");#define PLATFORM_DRIVER ixp4xx_ehci_driver#endif +#ifdef CONFIG_USB_W90X900_EHCI +#include "ehci-w90x900.c" +#define PLATFORM_DRIVER ehci_hcd_w90x900_driver +#endif +#if !defined(PCI_DRIVER ) && !defined(PLATFORM_DRIVER ) && \ !defined(PS3_SYSTEM_BUS_DRIVER ) && !defined(OF_PLATFORM_DRIVER )#error "missing bus glue for ehci-hcd"
drivers/usb/host/ehci-w90x900.c new file +181 -0
181 lines not on this page · raw message
Signature · 1 line
1.5.6.3