Skip to contentSkip to conversation

Don't match Dell devices on KERNEL, instead use ATTR{bInterfaceProtocol}

PATCH Applied Mario Limonciello 2 participants 2 messages Jun 15, 2009

lore
Share & tools
lore
#0 lore raw

PATCH 1/1 Don't match Dell devices on KERNEL, instead use ATTR{bInterfaceProtocol}

Hi:

For some reason I was getting mixed results where I couldn't get the rule to run properly with a git pull today and udev 142. ${attr} wasn't expanding like it should have been. I've modified the rule a bit and this one is now working correctly.

Regards

Signature · 3 lines
Mario Limonciello
*Dell | Linux Engineering*
[email protected]

=== modified file 'hid2hci/62-hid2hci.rules'

62-hid2hci.rules +2 -2
@@ -1,16 +1,16 @@
 # do not edit this file, it will be overwritten on update
 
 ACTION!="add", GOTO="hid2hci_end"
+SUBSYSTEM!="usb", GOTO="hid2hci_end"
 
 # Variety of Dell Bluetooth devices - it looks like a bit of an odd rule,
 # because it is matching on a mouse device that is self powered, but that
 # is where a HID report needs to be sent to switch modes.
 #
 # Known supported devices: 413c:8154, 413c:8158, 413c:8162
-KERNEL=="mouse*", SUBSYSTEMS=="usb", ATTRS{idVendor}=="413c", ATTRS{bmAttributes}=="e0", \
+ATTR{bInterfaceProtocol}=="02", ATTRS{idVendor}=="413c", ATTRS{bmAttributes}=="e0", \
     RUN+="hid2hci --method dell -v $attr{idVendor} -p $attr{idProduct} --mode hci"
 
-SUBSYSTEM!="usb", GOTO="hid2hci_end"
 ENV{DEVTYPE}!="usb_device", GOTO="hid2hci_end"
 
 # Logitech devices
Applied
#1 lore raw

Re: [PATCH] Don't match Dell devices on KERNEL, instead use

Quoted 4 lines · Mario Limonciello

For some reason I was getting mixed results where I couldn't get the rule to run properly with a git pull today and udev 142.  ${attr} wasn't expanding like it should have been.  I've modified the rule a bit and this one is now working correctly.

Applied.

Thanks,
Kay