ethernet phy attached to wrong driver
Hi
I'm having trouble with my Ethernet device on a TQM5200 based board with LXT971 Phy. I'm running U-Boot 2009.03 and a Kernel 2.6.30.
When doing a ping under U-Boot before booting into Linux, Ethernet works fine in Linux also. Dmesg reads:
[ 262.369444] net eth0: Using PHY at MDIO address 0 [ 263.265903] net eth0: attached phy 0 to driver LXT971
But if I start Linux without prior use of the fec under U-Boot, Ethernet is not working in Linux. The wrong drivers seems to be attached to the phy. Dmesg reads:
[ 2.068285] net eth0: Using PHY at MDIO address 0
[ 2.964774] net eth0: attached phy 0 to driver Generic PHY
^^^^^^^^^^^Is there a bootarg to tell linux which driver to use? Any ideas what I'm doing wrong?
Regards
Stefan.
Hi Stefan,
Quoted 8 lines
I'm having trouble with my Ethernet device on a TQM5200 based board with LXT971 Phy. I'm running U-Boot 2009.03 and a Kernel 2.6.30.
When doing a ping under U-Boot before booting into Linux, Ethernet works fine in Linux also. Dmesg reads:
[ 262.369444] net eth0: Using PHY at MDIO address 0 [ 263.265903] net eth0: attached phy 0 to driver LXT971
Quoted 8 lines
But if I start Linux without prior use of the fec under U-Boot, Ethernet is not working in Linux. The wrong drivers seems to be attached to the phy. Dmesg reads:
[ 2.068285] net eth0: Using PHY at MDIO address 0 [ 2.964774] net eth0: attached phy 0 to driver Generic PHY ^^^^^^^^^^^Is there a bootarg to tell linux which driver to use? Any ideas what I'm doing wrong?
I cannot reproduce this problem with a tqm5200/stk52xx combination. Linux always happily uses a genric PHY, irrelevant if I use networking in U-Boot.
Cheers
Detlev
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-40 Fax: (+49)-8142-66989-80 Email: [email protected]