Accessing PHY registers

On our custom AVR32 board, we've a pair of NatSemi DP83848 PHYs.

dmesg shows the following:-

MACB_mii_bus: probed
eth0: Atmel MACB at 0xfff01800 irq 25 (00:19:66:88:76:a4)
eth0: attached PHY driver [Generic PHY] (mii_bus:phy_addr=0:01, irq=-1) macb macb.1: invalid hw address, using random
MACB_mii_bus: probed
eth1: Atmel MACB at 0xfff01c00 irq 26 (42:36:af:ab:e4:b5)
eth1: attached PHY driver [Generic PHY] (mii_bus:phy_addr=1:03, irq=-1)

Can anyone shed some light on how I might read / write the PHY registers from userspace ?

I've looked at ethtool, but it doesn't appear to work:-

# ethtool eth0   
Settings for eth0:
	Supported ports: [ TP MII ]
	Supported link modes:   10baseT/Half 10baseT/Full 
	                        100baseT/Half 100baseT/Full 
	Supports auto-negotiation: Yes
	Advertised link modes:  10baseT/Half 10baseT/Full 
	                        100baseT/Half 100baseT/Full 
	Advertised auto-negotiation: Yes
	Speed: 100Mb/s
	Duplex: Full
	Port: MII
	PHYAD: 1
	Transceiver: external
	Auto-negotiation: on
	Link detected: yes
# ethtool -d eth0
Cannot get register dump: Operation not supported

Anyone got some sample code (I guess using sockets and ioctl calls ?) I could take a look at ?

Thanks
Mark

Hello Mark,

Did you find a way to realize what you were asking?

Thanks,
Turhan