Skip to contentSkip to conversation

2 default routes on non router

DISCUSSION Aleksander Kamenik 1 participant 2 messages Oct 8, 2009

lore
Share & tools
lore
#0 lore raw

Hi,

I have a server (srv) with two interfaces. One (IF_INT) is on an internal /24 network with a gateway (gw) which provides net access for the /24 lan. gw's internal interface is GW_INT.

The second (IF_EXT) is part of a public /28 network and has several IP addresses assigned.

Coincidently gw's public interface (GW_EXT) is part of the same /28 public network as IF_EXT.

The /28 network's gateway (GW_ISP) belongs to the ISP.

         ,-----|GW_INT|
        /      |  gw  |
       /       |GW_EXT|-------,
      /                        \
     /                          \
    /                            \
|IF_INT|                         /------|GW_ISP|----- internet
| srv  |                        /
|IF_EXT|                       /
   \                          /
    \________________________/

I want to use GW_INT as the default route, so connections originating from the server would leave IF_INT, go though GW_INT and have GW_EXT's IP when connecting the internet using SNAT.

However I also want IF_EXT to be available directly from the internet.

So far it's a standard out of the box setup. I just needed the server to be able to answer requests from the net directly through GW_ISP.

I tried to accomplish this by creating a second routing table on the server and adding the default route for GW_ISP there.

# ip route add default via $GW_ISP_IP dev $IF_EXT table extnet

Adding a rule to use the table for fwmark 10.

# ip rule add fwmark 10 table extnet

And using iptables CONNMARK to track the incoming connections on IF_EXT so I can assign them to extnet when the server replies.

This all works with one bigexception.

If I'm connecting to IF_EXT from an IP not listed in the main routing table, the packet is lost at "Routing Decision" [1]. I can connect to IF_EXT from GW_EXT or any other machine on the /28 network, but not from behing GW_ISP.

Although the route is available as default in the extnet table I have to add a internet located PC's route via GW_ISP to the main routing table for the PC to be able to connect.

I don't understand why the source IP matters during the "Routing Decision".

I tried marking the incoming packets so they would use the extnet table. For testing I tried adding the internet PC in extnet instead of main and that would not work also.

1 - http://iptables-tutorial.frozentux.net/images/tables_traverse.jpg

What's the correct solution to this problem?

Regards,

Signature · 9 lines
Aleksander Kamenik
System Administrator
Krediidiinfo AS
an Experian Company
Phone: +372 665 9649
Email: [email protected]

http://www.krediidiinfo.ee/
http://www.experiangroup.com/
#1 lore raw
Quoted 1 line · Aleksander Kamenik

I don't understand why the source IP matters during the "Routing Decision".

rp_filter!

/proc/sys/net/ipv4/conf/*/rp_filter

Regards,

Signature · 9 lines
Aleksander Kamenik
System Administrator
Krediidiinfo AS
an Experian Company
Phone: +372 665 9649
Email: [email protected]

http://www.krediidiinfo.ee/
http://www.experiangroup.com/