IXP425: help on HSS channelized service
Hi Krzysztof,
thanks for your answer..
Quoted 1 line
The buffers have different structures for RX and TX.
Do you refer to the tx_pointer_lists (which is not present for rx buffer)? The organization of rx and tx buffers isn't the same? If I want to read bytes of timeslot "ts" at offset "off", is it correct to read at position "chan_rx_buf(port) + CHAN_RX_FRAMES * ts + off"?
Quoted 1 line
Looks like a modified code from one of my ixp4xx-[0-9][0-9] branch.
It IS a modified code from your ixp4xx_hss.
Quoted 1 line
Have you tried using the original code in e.g. ixp4xx-31?
I cannot use right the original code because I need transfer callback in kernel space, not in user space..
Quoted 1 line
You may need to make some trivial changes related to "MVIP".
Sorry, what changes do you mean? Keep in mind I have one channel per timeslot (maybe you refer to the possibility to have more channels?)
Thank you!
Davide
Krzysztof Halasa ha scritto:
Quoted 29 lines
Quoted 7 lines · Davide Di Gesualdo
I'm writing a kernel module for a HSS channelized service on IXP425 processor, based on
ixp4xx_hss. I'm developing on a IXDPG425 Intel board, and the HSS bus is attached to four Si3210 ProSLIC chips. The purpose of this module is to read/write from/to HSS 8-byte buffers in raw mode (no particular alignment is required). In write direction, everything seems ok: if I write a buffer like
char buf[] = {0xcb,0xcb,0xcb,0xcb,0xcb,0xcb,0xcb,0xcb};Quoted 8 lines
on a fixed timeslot and then read the TXD pin signal with a scope, I can see the correct waveform at the correct place; I've also tried to write a tone with a fixed freqeuncy, and I've listened it correctly. The problem comes with read direction: I've tried to make a loopback by copying the rxbuffer in the txbuffer, but I can't hear my voice back (instead I hear something like a continous buzz). I'm quite sure I read the rxbuffer in the correct way (I do the same when I write txbuffer, which works properly!).
The buffers have different structures for RX and TX.
Quoted 2 lines
This is the ISR for HSS
read-complete interrupt:Looks like a modified code from one of my ixp4xx-[0-9][0-9] branch. Have you tried using the original code in e.g. ixp4xx-31? You may need to make some trivial changes related to "MVIP".
Not that my channelized HSS code is flawless or something, far from it, but it works, both directions.
Signature · 8 lines
Davide Di Gesualdo Kasko Networks S.r.l. P.zza Regina Margherita, 7 L'Aquila (AQ) - CAP 67100 - Italy Labs: +39 0862200460 Mobile: +39 3206203127 VoIP: +39 0857993233 Skype: davide.digesualdo