Skip to contentSkip to conversation

GPIO - MPC8315

U-Boot Marcos Cunha 2 participants 3 messages Dec 10, 2009 – Dec 14, 2009

lore
Share & tools
lore
#0 lore raw

I want to configure GPIOs on MPC8315, but I can't set the gpio. Below the configuration code and the output.

What is wrong?

#define SPI_CS_IO 0x20000000

int board_mmc_init(bd_t *bd)

{

    volatile immap_t *immr = (volatile immap_t *)CONFIG_SYS_IMMR;
    volatile gpio83xx_t *gpio = (volatile gpio83xx_t *)&immr->gpio[0];

    printf("INIT MMC\n");

    //tmpval = inbe32(
    out_be32(&gpio->dir,  SPI_CS_IO);  // Set IO as output
    out_be32(&gpio->odr, 0 /*~SPI_CS_IO*/); // Set pulled up
    out_be32(&gpio->ier,  SPI_CS_IO);  // Disable interrupt
    out_be32(&gpio->imr, 0 /*~SPI_CS_IO*/); // Disable interrupt mask
    out_be32(&gpio->icr, 0 /*~SPI_CS_IO*/); // Disable interrupt level/edge

    udelay(2000);
   
    out_be32(&gpio->dat, SPI_CS_IO);  // Set the output pin
 

     /*DEBUG*/
    printf("SPI - CHIP SELECT CONFIGURATION\n");
    printf("$gpio = %x\n", gpio);
    printf("gpio->dir = %x \n", gpio->dir );
    printf("gpio->odr = %x \n", gpio->odr );
    printf("gpio->ier = %x \n", gpio->ier );
    printf("gpio->imr = %x \n", gpio->imr );
    printf("gpio->icr = %x \n", gpio->icr );
    printf("gpio->dat = %x \n", gpio->dat );

}

This is the output.

MMC: INIT MMC
SPI - CHIP SELECT CONFIGURATION
$gpio = e0000c00
gpio->dir = 3f000000
gpio->odr = 0
gpio->ier = c00dff00
gpio->imr = 0
gpio->icr = 0
gpio->dat = 0
FINISH MMC

Thanks in advance,

Marcos Cunha
Electrical Engineer

#1 lore raw

Did you setup the System I/O Configuration Registers SICRL, SICRH?

Quoted 3 lines

I want to configure GPIOs on MPC8315, but I can't set the gpio. Below the configuration code and the output.

What is wrong?

#2 lore raw

That was the problem.

After GPIO configuration this line resolve the problem.

*setbits_be32(&immr->sysconf.sicrh, SICRH_GPIO_0 | SICRH_GPIO_1 | SICRH_GPIO_2);*

The DEBUG output:

SPI - CHIP SELECT CONFIGURATION
&gpio = e0000c00
gpio->dir = 3f000000
gpio->odr = 0
gpio->ier = e0bfff0f
gpio->imr = 0
gpio->icr = 0
*gpio->dat = e0000000 *

sysconf.sicrl = 0
*sysconf.sicrh = fc000000*

Thanks

Quoted 11 lines · G?nter Leonhardt

Did you setup the System I/O Configuration Registers SICRL, SICRH?

Quoted 4 lines

I want to configure GPIOs on MPC8315, but I can't set the gpio. Below the configuration code and the output.

What is wrong?