ath9k driver in kernel 2.6.33 problems
Hi,
I've been trying to use the last couple of 2.6.33 RCs up to rc3-git2 and am experiencing connection issues with the ath9k driver. It used to be broken for me in kernel 2.6.31 (haven't tried earlier), then was rock-solid in 2.6.32 and now it's broken again. I can connect to my 300mbit router--which is in the same room--without problems, but after a while the connection breaks.
Jan 7 22:36:27 gentoo kernel: [ 5.819124] ath9k 0000:03:00.0: PCI INT A -> GSI 18 (level, low) -> IRQ 18 Jan 7 22:36:27 gentoo kernel: [ 5.819137] ath9k 0000:03:00.0: setting latency timer to 64 Jan 7 22:36:27 gentoo kernel: [ 5.869898] ath: EEPROM regdomain: 0x60 Jan 7 22:36:27 gentoo kernel: [ 5.869900] ath: EEPROM indicates we should expect a direct regpair map Jan 7 22:36:27 gentoo kernel: [ 5.869906] ath: Country alpha2 being used: 00 Jan 7 22:36:27 gentoo kernel: [ 5.869907] ath: Regpair used: 0x60 Jan 7 22:36:27 gentoo kernel: [ 5.874261] phy0: Selected rate control algorithm 'ath9k_rate_control' Jan 7 22:36:27 gentoo kernel: [ 5.875006] Registered led device: ath9k-phy0::radio Jan 7 22:36:27 gentoo kernel: [ 5.875025] Registered led device: ath9k-phy0::assoc Jan 7 22:36:27 gentoo kernel: [ 5.875074] Registered led device: ath9k-phy0::tx Jan 7 22:36:27 gentoo kernel: [ 5.875098] Registered led device: ath9k-phy0::rx Jan 7 22:36:27 gentoo kernel: [ 5.875113] phy0: Atheros AR9285 Rev:2
mem=0xffffc90011100000, irq=18
Jan 7 22:36:27 gentoo kernel: [ 11.287482] ADDRCONF(NETDEV_UP): wlan0: link is not ready Jan 7 22:36:27 gentoo kernel: [ 12.179291] Adding 8000328k swap on /dev/sda5. Priority:-1 extents:1 across:8000328k Jan 7 22:36:27 gentoo kernel: [ 13.014980] ath9k: Two wiphys trying to scan at the same time Jan 7 22:36:27 gentoo kernel: [ 13.217106] wlan0: direct probe to AP 00:1f:3f:d3:4d:2a (try 1) Jan 7 22:36:27 gentoo kernel: [ 13.221958] wlan0: direct probe responded Jan 7 22:36:27 gentoo kernel: [ 13.221965] wlan0: authenticate with AP 00:1f:3f:d3:4d:2a (try 1) Jan 7 22:36:27 gentoo kernel: [ 13.225266] wlan0: authenticated Jan 7 22:36:27 gentoo kernel: [ 13.225304] wlan0: associate with AP 00:1f:3f:d3:4d:2a (try 1) Jan 7 22:36:27 gentoo kernel: [ 13.229132] wlan0: RX AssocResp from 00:1f:3f:d3:4d:2a (capab=0x431 status=0 aid=1) Jan 7 22:36:27 gentoo kernel: [ 13.229137] wlan0: associated Jan 7 22:36:27 gentoo kernel: [ 13.237383] ADDRCONF(NETDEV_CHANGE): wlan0: link becomes ready Jan 7 22:36:27 gentoo dhcpcd: version 5.1.4 starting Jan 7 22:36:27 gentoo dhcpcd: wlan0: rebinding lease of 192.168.1.120 Jan 7 22:36:31 gentoo dhcpcd: wlan0: reject NAK Jan 7 22:36:37 gentoo kernel: [ 24.189064] wlan0: no IPv6 routers present Jan 7 22:36:37 gentoo dhcpcd: wlan0: broadcasting for a lease Jan 7 22:36:37 gentoo dhcpcd: wlan0: offered 192.168.1.120 from 192.168.1.1 Jan 7 22:36:42 gentoo dhcpcd: wlan0: acknowledged 192.168.1.120 from 192.168.1.1 Jan 7 22:36:42 gentoo dhcpcd: wlan0: checking for 192.168.1.120 Jan 7 22:36:47 gentoo dhcpcd: wlan0: leased 192.168.1.120 for 864000 seconds Jan 7 22:36:47 gentoo dhcpcd: forking to background
Jan 8 00:07:19 gentoo kernel: [ 5466.181635] wlan0: deauthenticated from 00:1f:3f:d3:4d:2a (Reason: 2) Jan 8 00:07:19 gentoo dhcpcd: wlan0: carrier lost Jan 8 00:07:19 gentoo wpa_cli: interface wlan0 DISCONNECTED Jan 8 00:07:21 gentoo kernel: [ 5467.472581] wlan0: direct probe to AP 00:1f:3f:d3:4d:2a (try 1) Jan 8 00:07:21 gentoo kernel: [ 5467.477331] wlan0: direct probe responded Jan 8 00:07:21 gentoo kernel: [ 5467.477338] wlan0: authenticate with AP 00:1f:3f:d3:4d:2a (try 1) Jan 8 00:07:21 gentoo kernel: [ 5467.480769] wlan0: authenticated Jan 8 00:07:21 gentoo kernel: [ 5467.480802] wlan0: associate with AP 00:1f:3f:d3:4d:2a (try 1) Jan 8 00:07:21 gentoo kernel: [ 5467.484611] wlan0: RX ReassocResp from 00:1f:3f:d3:4d:2a (capab=0x431 status=0 aid=1) Jan 8 00:07:21 gentoo kernel: [ 5467.484616] wlan0: associated Jan 8 00:07:21 gentoo dhcpcd: wlan0: carrier acquired Jan 8 00:07:21 gentoo dhcpcd: wlan0: rebinding lease of 192.168.1.120 Jan 8 00:07:21 gentoo dhcpcd: wlan0: reject NAK Jan 8 00:07:24 gentoo dhcpcd: received SIGTERM, stopping Jan 8 00:07:24 gentoo dhcpcd: wlan0: removing interface Jan 8 00:07:24 gentoo wpa_cli: interface wlan0 CONNECTED Jan 8 00:07:24 gentoo dhcpcd: version 5.1.4 starting Jan 8 00:07:24 gentoo dhcpcd: wlan0: rebinding lease of 192.168.1.120 Jan 8 00:07:24 gentoo dhcpcd: wlan0: reject NAK Jan 8 00:07:28 gentoo dhcpcd: wlan0: reject NAK Jan 8 00:07:32 gentoo dhcpcd: wlan0: reject NAK Jan 8 00:07:34 gentoo dhcpcd: wlan0: broadcasting for a lease Jan 8 00:07:34 gentoo dhcpcd: wlan0: offered 192.168.1.120 from 192.168.1.1 Jan 8 00:07:34 gentoo dhcpcd: wlan0: acknowledged 192.168.1.120 from 192.168.1.1 Jan 8 00:07:34 gentoo dhcpcd: wlan0: checking for 192.168.1.120 Jan 8 00:07:40 gentoo dhcpcd: wlan0: leased 192.168.1.120 for 864000 seconds Jan 8 00:07:40 gentoo dhcpcd: forking to background
Is there anything else I could log?
Regards,
Rainer
Quoted 8 lines · Rainer Koschnick
Hi,
I've been trying to use the last couple of 2.6.33 RCs up to rc3-git2 and am experiencing connection issues with the ath9k driver. It used to be broken for me in kernel 2.6.31 (haven't tried earlier), then was rock-solid in 2.6.32 and now it's broken again. I can connect to my 300mbit router--which is in the same room--without problems, but after a while the connection breaks.
You could build the driver with CONFIG_ATH_DEBUG=y and CONFIG_ATH9K_DEBUGFS=y and post the log, along with the contents of 'rcstat' and 'interrupt' debugfs files.
See: http://wireless.kernel.org/en/users/Drivers/ath9k/debug
Sujith
Quoted 13 lines · Sujith
Quoted 8 lines · Rainer Koschnick
Hi,
I've been trying to use the last couple of 2.6.33 RCs up to rc3-git2 and am experiencing connection issues with the ath9k driver. It used to be broken for me in kernel 2.6.31 (haven't tried earlier), then was rock-solid in 2.6.32 and now it's broken again. I can connect to my 300mbit router--which is in the same room--without problems, but after a while the connection breaks.
You could build the driver with
CONFIG_ATH_DEBUG=yandCONFIG_ATH9K_DEBUGFS=yand post the log, along with the contents of 'rcstat' and 'interrupt' debugfs files.
Quoted 8 lines
See: http://wireless.kernel.org/en/users/Drivers/ath9k/debug
Sujith
--
To unsubscribe from this list: send the line "unsubscribe linux-wireless" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html
Hi,
I have uploaded the requested information to my server, it's rather big so I don't want to post it here.
http://arkay.de/temp/ath9k_debug.tar.bz
Since the messages file is around 1GB I have extracted a couple of time ranges. First I had a disconnect (messages.reconnect... dhcpcd complained at 20:47:24) , then later the network connection just hang for a minute or two. I was transferring a big file from a LAN server, must have happened somewhere around 21:08 or 09 (messages.hang). The transfer just hang... neither the web nor ping worked.
I still have the messages file saved should anything be missing, I have now turned debugging off since I don't have that much space on my notebook :)
Thanks,
Rainer