Scan of already paired devices
Quoted 2 lines · Philip Oberstaller
Thus anybody know what I could do from the host side to be able to make the device "visible" again.
Obviously, you cannot control the device from the host if you are not even connected to it..
What device is it? If it is a phone then it may be possible to make it visible always, but many limited connection devices (HID, or headphones etc) will not advertise themselves if they have a pairing as there is no point to do that and it wastes power.
regards,
iain
Hello,
I would like to know if it's possible to see already paired devices in the scan results?
My scenario is the following:
First I create a connection from my host to a device and pair the device and the host. Then I disconnect the connection by simply switching off the device. I remove the pairing at the host but obviously cannot remove the pairing from the device because there is no connection anymore. If I then switch on the device again I am not able to find it in the scanning results because the device has stored the "old" pairing and thus seems to be invisible.
The device reappears in the scanning results only when I remove the pairing at the device itself.
Thus anybody know what I could do from the host side to be able to make the device "visible" again.
I am forced to use a quiet old bluez version 3.33. Maybe this behavior has changed in the meantime?
I am grateful for any hints.
Philip Oberstaller