IGEPv2: Added WIFI support
Subsystems (3)
PATCH 1/2 IGEPv2: Added WIFI support
Enabled VMMC2 LDO voltage regulator on TWL4030. Added GPIO's (power down and reset) for WIFI chip.
Signed-off-by Anders Hedlund <[email protected]>
Signed-off-by Jonas Zetterberg <[email protected]>
--- arch/arm/mach-omap2/board-igep0020.c | 40 ++++++++++++++++++++++++++++++++++ 1 files changed, 40 insertions(+), 0 deletions(-)
arch/arm/mach-omap2/board-igep0020.c +40 -0
@@ -42,6 +42,8 @@#define IGEP2_GPIO_LED0_GREEN 27#define IGEP2_GPIO_LED1_RED 28#define IGEP2_GPIO_DVI_PUP 170 +#define IGEP2_GPIO_WIFI_NPD 94 +#define IGEP2_GPIO_WIFI_NRESET 95#if defined(CONFIG_MTD_ONENAND_OMAP2 ) || \ defined(CONFIG_MTD_ONENAND_OMAP2_MODULE )
@@ -209,6 +211,10 @@ static struct regulator_consumer_supply igep2_vmmc1_supply = { .supply = "vmmc", }; +static struct regulator_consumer_supply igep2_vmmc2_supply = { + .supply ="vmmc" , +}; +/* VMMC1 for OMAP VDD_MMC1 (i/o) and MMC1 card */ static struct regulator_init_data igep2_vmmc1 = { .constraints = {
@@ -224,6 +230,21 @@ static struct regulator_init_data igep2_vmmc1 = { .consumer_supplies = &igep2_vmmc1_supply, }; +/* VMMC2 for OMAP VDD_MMC2 (i/o) and MMC2 WIFI */ +static struct regulator_init_data igep2_vmmc2 = { + .constraints = { + .min_uV =1850000 , + .max_uV =3150000 , + .valid_modes_mask =REGULATOR_MODE_NORMAL + |REGULATOR_MODE_STANDBY , + .valid_ops_mask =REGULATOR_CHANGE_VOLTAGE + |REGULATOR_CHANGE_MODE + |REGULATOR_CHANGE_STATUS , + }, + .num_consumer_supplies =1 , + .consumer_supplies = &igep2_vmmc2_supply, +}; +static struct omap2_hsmmc_info mmc[] = { { .mmc =1 ,
@@ -251,6 +272,7 @@ static int igep2_twl_gpio_setup(struct device *dev,* regulators will be set up only *after* we return. */ igep2_vmmc1_supply.dev = mmc[0 ].dev; + igep2_vmmc2_supply.dev = mmc[1 ].dev;return 0 ; };
@@ -364,6 +386,7 @@ static struct twl4030_platform_data igep2_twldata = { .codec = &igep2_codec_data, .gpio = &igep2_gpio_data, .vmmc1 = &igep2_vmmc1, + .vmmc2 = &igep2_vmmc2, .vpll2 = &igep2_vpll2, };
@@ -446,6 +469,23 @@ static void __init igep2_init(void)gpio_set_value (IGEP2_GPIO_LED1_RED ,0 ); }else pr_warning ("IGEP v2: Could not obtain gpio GPIO_LED1_RED\n" ); + +/* GPIO W-LAN + Bluetooth combo module */ +if ((gpio_request (IGEP2_GPIO_WIFI_NPD ,"GPIO_WIFI_NPD" ) ==0 ) && + (gpio_direction_output (IGEP2_GPIO_WIFI_NPD ,1 ) ==0 )) { +gpio_export (IGEP2_GPIO_WIFI_NPD ,0 ); +/* gpio_set_value(IGEP2_GPIO_WIFI_NPD, 0); */ + }else +pr_warning ("IGEP v2: Could not obtain gpio GPIO_WIFI_NPD\n" ); + +if ((gpio_request (IGEP2_GPIO_WIFI_NRESET ,"GPIO_WIFI_NRESET" ) ==0 ) && + (gpio_direction_output (IGEP2_GPIO_WIFI_NRESET ,1 ) ==0 )) { +gpio_export (IGEP2_GPIO_WIFI_NRESET ,0 ); +gpio_set_value (IGEP2_GPIO_WIFI_NRESET ,0 ); +udelay (10 ); +gpio_set_value (IGEP2_GPIO_WIFI_NRESET ,1 ); + }else +pr_warning ("IGEP v2: Could not obtain gpio GPIO_WIFI_NRESET\n" ); }static void __init igep2_map_io (void )
Tony Lindgren
maintainerPATCH 1/2 IGEPv2: Added WIFI support
This patch has been applied to the linux-omap
by youw fwiendly patch wobot.
Branch in linux-omap: for-next
Initial commit ID (Likely to change): ca634ecdd562e6e6dd647859ce3037b6261b51d5
PatchWorks
http://patchwork.kernel.org/patch/79312/
Git (Likely to change, and takes a while to get mirrored)
http://git.kernel.org/?p=linux/kernel/git/tmlind/linux-omap-2.6.git;a=commit;h=ca634ecdd562e6e6dd647859ce3037b6261b51d5