Skip to contentSkip to conversation

Possible problem in sctp_getsockopt_peer_addrs (and similar functions)

DISCUSSION Sebastien Decugis 2 participants 2 messages Feb 19, 2010 SCTP protocol

lore
Share & tools
lore
#0 lore raw

Hello list,

I think there is a problem in sctp_getsockopt_peer_addrs function in net/sctp/socket.c.

I run into the problem when I call sctp_getpaddrs in userland, with a buffer containing IPv4 address followed by IPv6. The address buffer I receive cannot be parsed. After correctly reading the first address, I am not aligned correctly when I move my pointer forward by sizeof(struct sockaddr_in), to read the next address. I am not using mapped addresses. I believe the source of the problem being the following code:

list_for_each_entry(from, &asoc->peer.transport_addr_list,

                              transports) {
    memcpy(&temp, &from->ipaddr, sizeof(temp));
    sctp_get_pf_specific(sk->sk_family)->addr_v4map(sp, &temp);
    addrlen = sctp_get_af_specific(sk->sk_family)->sockaddr_len;

In this last line, shouldn't the address be dependent on the address family of &temp, rather than the socket ?

Sorry if the format of my mail is not good, it is my first post here... I am also not subscribed to this list, so please CC me in any answer.

Best regards,
Sebastien.

Signature · 4 lines
Sebastien Decugis
Research fellow
Network Architecture Group
NICT (nict.go.jp)
#1 lore raw

Hi Sebastien

Quoted 18 lines · Sebastien Decugis

Hello list,

I think there is a problem in sctp_getsockopt_peer_addrs function in net/sctp/socket.c.

I run into the problem when I call sctp_getpaddrs in userland, with a buffer containing IPv4 address followed by IPv6. The address buffer I receive cannot be parsed. After correctly reading the first address, I am not aligned correctly when I move my pointer forward by sizeof(struct sockaddr_in), to read the next address. I am not using mapped addresses. I believe the source of the problem being the following code:

list_for_each_entry(from, &asoc->peer.transport_addr_list,

                              transports) {
    memcpy(&temp, &from->ipaddr, sizeof(temp));
    sctp_get_pf_specific(sk->sk_family)->addr_v4map(sp, &temp);
    addrlen = sctp_get_af_specific(sk->sk_family)->sockaddr_len;
Quoted 9 lines

In this last line, shouldn't the address be dependent on the address family of &temp, rather than the socket ?

Sorry if the format of my mail is not good, it is my first post here... I am also not subscribed to this list, so please CC me in any answer.

Best regards,
Sebastien.

You are correct. The address length used is totally wrong. The length should depend on the family of the address stored in the 'temp' variable as that is the address that will be copied out to user.

I'll fix it up.

Thanks
-vlad