dm: restore presuspend status
RFC PATCH 1/4 dm: restore presuspend status
When suspend procedure was interrupted just after a target's presuspend method was executed, dm_suspend() calls the target's resume method to cancel the target's state changes.
Signed-off-by Takahiro Yasui <[email protected]>
--- drivers/md/dm.c | 7 +++++-- 1 file changed, 5 insertions(+), 2 deletions(-)
drivers/md/dm.c +5 -2
@@ -2475,7 +2475,6 @@ int dm_suspend(struct mapped_device *md,if (noflush)set_bit (DMF_NOFLUSH_SUSPENDING , &md->flags); -/* This does not get reverted if there's an error later. */ dm_table_presuspend_targets (map);/*
@@ -2486,8 +2485,10 @@ int dm_suspend(struct mapped_device *md,*/ if (!noflush && do_lockfs) { r =lock_fs (md); -if (r) +if (r) { +dm_table_resume_targets (map); goto out; + } }/*
@@ -2541,6 +2542,8 @@ int dm_suspend(struct mapped_device *md,start_queue (md->queue);unlock_fs (md); + +dm_table_resume_targets (map); goto out;/* pushback list is already flushed, so skip flush */ }
--
lvm-devel mailing list
[email protected]
https://www.redhat.com/mailman/listinfo/lvm-devel