batctl: include ping -R in manpage
PATCH 1/1 batctl: include ping -R in manpage
This patch adds documentation for the ping -R option to the batctl manpage.
Signed-off-by Daniel Seither <[email protected]>
---
man/batctl.8 +3 -2
@@ -126,14 +126,15 @@ Otherwise the parameter is used to enable or disable packet aggregation. .br -.IP "\fBping\fP|\fBp\fP [\fB\-c \fP\fIcount\fP][\fB\-i \fP\fIinterval\fP][\fB\-t \fP\fItime\fP] \fIMAC_address\fP|\fIbat\-host_name\fP" +.IP "\fBping\fP|\fBp\fP [\fB\-c \fP\fIcount\fP][\fB\-i \fP\fIinterval\fP][\fB\-t \fP\fItime\fP][\fB\-R\fP] \fIMAC_address\fP|\fIbat\-host_name\fP" Layer 2 ping of a MAC address or bat\-host name. batctl will try to find the bat\-host name if the given parameter was not a MAC address. The "\-c" option tells batctl how man pings should be sent before the program exits. Without the "\-c" option batctl will continue pinging without end. Use CTRL + C to stop it. With "\-i" and "\-t" you can set the default interval between pings and the timeout time -for replies, both in seconds. +for replies, both in seconds. When run with "\-R", the route taken by +the ping messages will be recorded. .br .IP "\fBtraceroute\fP|\fBtr\fP [\fB\-n\fP] \fIMAC_address\fP|\fIbat\-host_name\fP" Layer 2 traceroute to a MAC address or bat\-host name. batctl will try
Marek Lindner
AppliedQuoted 1 line · On Thursday 04 March 2010 20:15:07 Daniel Seither wrote:
This patch adds documentation for the ping -R option to the batctl manpage.
Applied in revision 1580.
Thanks,
Marek