powerpc: do not call prink when CONFIG_PRINTK is not defined
PATCH 1/1 powerpc: do not call prink when CONFIG_PRINTK is not defined
From: Márton Németh <[email protected]>
When printk() is disabled (CONFIG_PRINTK) at menu item
General setup
-> Configure standard kernel features (for small systems)
-> Enable support for printk
then there should be no printk() calls at all.
Signed-off-by Márton Németh <[email protected]>
---
arch/powerpc/kernel/head_fsl_booke.S +4 -0
@@ -887,13 +887,17 @@ KernelSPE: lwz r3,_MSR(r1) oris r3,r3,MSR_SPE@h stw r3,_MSR(r1) /* enable use of SPE after return */ +#ifdef CONFIG_PRINTK lis r3,87f@h ori r3,r3,87f@l mr r4,r2 /* current */ lwz r5,_NIP(r1) bl printk +#endif b ret_from_except +#ifdef CONFIG_PRINTK 87: .string "SPE used in kernel (task=%p, pc=%x) \n" +#endif .align 4,0 #endif /* CONFIG_SPE */
PATCH 1/1 powerpc: do not call printk when CONFIG_PRINTK is not defined
From: Márton Németh <[email protected]>
When printk() is disabled (CONFIG_PRINTK) at menu item
General setup
-> Configure standard kernel features (for small systems)
-> Enable support for printk
then there should be no printk() calls at all.
Signed-off-by Márton Németh <[email protected]>
---
Just a typo was fixed in the title.
---
arch/powerpc/kernel/head_fsl_booke.S +4 -0
@@ -887,13 +887,17 @@ KernelSPE: lwz r3,_MSR(r1) oris r3,r3,MSR_SPE@h stw r3,_MSR(r1) /* enable use of SPE after return */ +#ifdef CONFIG_PRINTK lis r3,87f@h ori r3,r3,87f@l mr r4,r2 /* current */ lwz r5,_NIP(r1) bl printk +#endif b ret_from_except +#ifdef CONFIG_PRINTK 87: .string "SPE used in kernel (task=%p, pc=%x) \n" +#endif .align 4,0 #endif /* CONFIG_SPE */