net, kirkwood_egiga: setup the mac address in the device registers
PATCH v2 2/2 net, kirkwood_egiga: setup the mac address in the device registers
always setup mac address register with the contents in ethaddr.
This is not in line with u-boot design principle "not to initalize not used devices", and maybe should go away, if there is a solution for passing the mac address to arm linux kernels.
Tested on the suen3 board.
Signed-off-by Heiko Schocher <[email protected]>
---
- changes since v1 posted here:
http://lists.denx.de/pipermail/u-boot/2010-March/069193.html
- split in two patches as Wolfgang suggested
drivers/net/kirkwood_egiga.c | 1 + 1 files changed, 1 insertions(+), 0 deletions(-)
drivers/net/kirkwood_egiga.c +1 -0
@@ -687,6 +687,7 @@ int kirkwood_egiga_initialize(bd_t * bis) dev->enetaddr[4 ] =get_random_hex (); dev->enetaddr[5 ] =get_random_hex (); } +port_uc_addr_set (dkwgbe->regs, dev->enetaddr); dev->init = (void *)kwgbe_init; dev->halt = (void *)kwgbe_halt;
Signature · 5 lines
1.6.2.5 -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany