pckbd: support for commands 0xf0-0xff: Pulse output bit
PATCH 1/1 pckbd: support for commands 0xf0-0xff: Pulse output bit
I use a legacy guest OS which sends the command 0xfd to the keyboard controller during initialization. To get rid of the message "qemu: unsupported keyboard cmd=0x%02x\n" I added support for the pulse output bit commands.
--- hw/pckbd.c | 23 ++++++++++++++++++++--- 1 files changed, 20 insertions(+), 3 deletions(-)
hw/pckbd.c +0 -0
@@ -50,7 +50,9 @@#define KBD_CCMD_WRITE_MOUSE 0xD4/* Write the following byte to
the mouse */
#define KBD_CCMD_DISABLE_A20 0xDD /* HP vectra only ? */ #define KBD_CCMD_ENABLE_A20 0xDF /* HP vectra only ? */ -#define KBD_CCMD_RESET 0xFE +#define KBD_CCMD_PULSE_BITS_3_0 0xF0 /* Pulse bits 3-0 of the output port P2. */ +#define KBD_CCMD_RESET 0xFE /* Pulse bit 0 of the output port P2 = CPU reset. */ +#define KBD_CCMD_NO_OP 0xFF /* Pulse no bits of the output port P2. */
/* Keyboard Commands */
#define KBD_CMD_SET_LEDS 0xED /* Set keyboard leds */
@@ -203,6 +205,21 @@ static void kbd_write_command(void *opaque, uint32_t addr, uint32_t val)
#ifdef DEBUG_KBD
printf("kbd: write cmd=0x%02x\n", val);
#endif
+
+ /* Bits 3-0 of the output port P2 of the keyboard controller may be pulsed
+ * low for approximately 6 micro seconds. Bits 3-0 of the KBD_CCMD_PULSE
+ * command specify the output port bits to be pulsed.
+ * 0: Bit should be pulsed. 1: Bit should not be modified.
+ * The only useful version of this command is pulsing bit 0,
+ * which does a CPU reset.
+ */+ if((val & KBD_CCMD_PULSE_BITS_3_0) == KBD_CCMD_PULSE_BITS_3_0) {
+ if(!(val & 1))
+ val = KBD_CCMD_RESET;
+ else
+ val = KBD_CCMD_NO_OP;
+ }
+
switch(val) {
case KBD_CCMD_READ_MODE:
kbd_queue(s, s->mode, 0);
@@ -265,8 +282,8 @@ static void kbd_write_command(void *opaque, uint32_t addr, uint32_t val)
case KBD_CCMD_RESET:
qemu_system_reset_request();
break;- case 0xff:
- /* ignore that - I don't know what is its use */
+ case KBD_CCMD_NO_OP:
+ /* ignore that */
break;
default:
fprintf(stderr, "qemu: unsupported keyboard cmd=0x%02x\n", val);Signature · 1 line
1.6.6.1