Change the default PLE_Gap
PATCH 1/1 Change the default PLE_Gap
Changed the default PLE_Gap to 128 for
1. not using odd number like 41
2. getting a little bit more PLE vmexits to improve performance
Signed-off-by Zhai Edwin <[email protected]>
Signature · 2 lines
best rgds, edwin
Changed the default PLE_Gap to 128 for
1. not using odd number like 41
2. getting a little bit more PLE vmexits to improve performance
Signed-off-by Zhai Edwin <[email protected]>
xen/arch/x86/hvm/vmx/vmcs.c +1 -1
@@ -53,7 +53,7 @@ boolean_param("unrestricted_guest", opt_* Time is measured based on a counter that runs at the same rate as the TSC, * refer SDM volume 3b section 21.6.13 & 22.1.3. */ -static unsigned int __read_mostly ple_gap =41 ; +static unsigned int __read_mostly ple_gap =128 ;integer_param ("ple_gap" , ple_gap);static unsigned int __read_mostly ple_window =4096 ;integer_param ("ple_window" , ple_window);
_______________________________________________
Xen-devel mailing list [email protected]
http://lists.xensource.com/xen-devel