Skip to contentSkip to conversation

Does anyone care about gcc 3.x support for *x86* anymore?

DISCUSSION H. Peter Anvin 6 participants 7 messages May 19, 2010 – May 20, 2010

lore
Share & tools
lore
#0 lore raw

[Reposting as a separate thread]

Recently, we have seen an increasing number of problems with gcc 3.4 on x86; mostly due to poor constant propagation producing not just bad code but failing to properly eliminate what should be dead code.

I'm wondering if there is any remaining real use of gcc 3.4 on x86 for compiling current kernels (as opposed to residual use for compiling applications on old enterprise distros.) I'm specifically not referring to other architectures here -- most of these issues have been in relation to low-level arch-specific code, and as such only affects the x86 architectures. Other architectures may very well have a much stronger need for continued support of an older toolchain.

If there isn't a reason to preserve support, I would like to consider discontinue support for using gcc 3 to compile x86 kernels. If there is a valid use case, it would be good to know what it is.

-hpa

Signature · 2 lines
H. Peter Anvin, Intel Open Source Technology Center
I work for Intel.  I don't speak on their behalf.
#1 lore raw

(reposted with Andrew and Linus Cc:-ed too)

Quoted 27 lines · H. Peter Anvin

[Reposting as a separate thread]

Recently, we have seen an increasing number of problems with gcc 3.4 on x86; mostly due to poor constant propagation producing not just bad code but failing to properly eliminate what should be dead code.

I'm wondering if there is any remaining real use of gcc 3.4 on x86 for compiling current kernels (as opposed to residual use for compiling applications on old enterprise distros.) I'm specifically not referring to other architectures here -- most of these issues have been in relation to low-level arch-specific code, and as such only affects the x86 architectures. Other architectures may very well have a much stronger need for continued support of an older toolchain.

If there isn't a reason to preserve support, I would like to consider discontinue support for using gcc 3 to compile x86 kernels. If there is a valid use case, it would be good to know what it is.

-hpa

Signature · 2 lines
H. Peter Anvin, Intel Open Source Technology Center
I work for Intel.  I don't speak on their behalf.
#2 lore raw
In reply to H. Peter Anvin
Quoted 4 lines · H. Peter Anvin

If there isn't a reason to preserve support, I would like to consider discontinue support for using gcc 3 to compile x86 kernels. If there is a valid use case, it would be good to know what it is.

I suspect there are still distributions around that use it as a standard compiler. Wasn't it used in some major release of Debian?

-Andi

Signature · 1 line
[email protected] -- Speaking for myself only.
#3 lore raw
Quoted 10 lines · Andi Kleen
Quoted 4 lines · H. Peter Anvin

If there isn't a reason to preserve support, I would like to consider discontinue support for using gcc 3 to compile x86 kernels. If there is a valid use case, it would be good to know what it is.

I suspect there are still distributions around that use it as a standard compiler. Wasn't it used in some major release of Debian?

-Andi

There are, but that doesn't mean it's relevant for people to compile bleeding-edge kernels with it.

-hpa

Signature · 2 lines
H. Peter Anvin, Intel Open Source Technology Center
I work for Intel.  I don't speak on their behalf.
#4 lore raw
Quoted 10 lines · H. Peter Anvin
Quoted 9 lines · Andi Kleen
Quoted 4 lines · H. Peter Anvin

If there isn't a reason to preserve support, I would like to consider discontinue support for using gcc 3 to compile x86 kernels. If there is a valid use case, it would be good to know what it is.

I suspect there are still distributions around that use it as a standard compiler. Wasn't it used in some major release of Debian?

Quoted 7 lines
Quoted 1 line

-Andi

There are, but that doesn't mean it's relevant for people to compile bleeding-edge kernels with it.

-hpa

no need for it here(using 4.6.0)..
Any distro still using this version
should upgrade(but who am I to say anything)

cheers.

Justin P. Mattock

#5 lore raw
In reply to Andi Kleen
Quoted 6 lines · Andi Kleen
Quoted 3 lines

If there isn't a reason to preserve support, I would like to consider discontinue support for using gcc 3 to compile x86 kernels. If there is a valid use case, it would be good to know what it is.

I suspect there are still distributions around that use it as a standard compiler. Wasn't it used in some major release of Debian?

Not in a recent one, no.

Signature · 2 lines
Martin Michlmayr
http://www.cyrius.com/
#6 lore raw
Quoted 9 lines · Martin Michlmayr
Quoted 6 lines · Andi Kleen
Quoted 3 lines

If there isn't a reason to preserve support, I would like to consider discontinue support for using gcc 3 to compile x86 kernels.  If there is a valid use case, it would be good to know what it is.

I suspect there are still distributions around that use it as a standard compiler. Wasn't it used in some major release of Debian?

Not in a recent one, no.

Not even in oldstable (etch).

Quoted 9 lines

--
Martin Michlmayr
http://www.cyrius.com/
--
To unsubscribe from this list: send the line "unsubscribe linux-kernel" in the body of a message to [email protected]
More majordomo info at  http://vger.kernel.org/majordomo-info.html
Please read the FAQ at  http://www.tux.org/lkml/