strange characters on serial port when booting kernel on at91sam9263 board
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Hi,
I have a board which is based on the AT91SAM9263-EK but with a little but annoying difference: SDRAM is smaller.
Thus I cannot use prebuilt images. I've compiled AT91Bootstrap-1.15 which directly loads the linux kernel (2.6.34).
I've tried a linux kernel built with buildroot and one compiled on my own using the toolchain of buildroot. Both are in uncompressed uImage format.
When watching the serial port I get the output shown here [1]. After the last line, part [2] shows up. That looks like a wrong speed of the serial port. But I've tried all known speeds (using cu) but no good characters are showing up. :(
The serial port is configured for 115200 baud. I am starting linux with console=ttyS0,115200.
I think this is a problem with the kernel, maybe a wrong frequency or baud rate?
What can I try to get the kernel running on this board?
Is it better to compile the kernel on my own? What patches are recommended? Do I need to change the SDRAM size somewhere in the kernel sources or is this detected automatically?
Thanks a lot in advance,
Martin
[1] (please do not feel disturbed by some debugging output) RomBOOT
Quoted 1 line
Start AT91Bootstrap...
init SDRAM
init sdramc_hwsdramc_hw ok
SDRAM ok
======= load image header from nandflash =======
init nandflash_hwnandflash_hw init oknandflash_cfg_8bits_dbw_init ok
======= load image from nandflash =======
init nandflash_hwnandflash_hw init oknandflash_cfg_8bits_dbw_init ok
======= jump to entry point =======
Uncompressing Linux... done, booting the kernel.
[2]
?*S???N???A?
?1?Y?HWK???x*??A?
???V?,1?q?*P/?????Y$?a?#
???e?1(and so on)
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v2.0.14 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org/
iEYEARECAAYFAkwCgVkACgkQE5UqXaCvB8LyPgCgkjIUi3cMCOTzxqFey+OqKtE5 qq4AoLFu5OHbima0ipQNuj6PZ7qOH8Fq
=vfNO
-----END PGP SIGNATURE-----