Skip to contentSkip to conversation

e1000e probe failure on 2.6.34 and higher, Intel MB

DISCUSSION Tim Gardner 2 participants 2 messages Jun 10, 2010

lore
Share & tools
lore
#0 lore raw

Hi,

http://bugs.launchpad.net/bugs/591707

I've a bug where e1000e works with Lucid (2.6.32), but fails to probe with 2.6.35-rc2. The output is mighty terse.

[   28.193628] e1000e 0000:00:19.0: PCI INT A disabled
[   28.193740] e1000e: probe of 0000:00:19.0 failed with error -3

The full dmesg logs are at https://bugs.edge.launchpad.net/ubuntu/+source/linux/+bug/591707/comments/23 and https://bugs.edge.launchpad.net/ubuntu/+source/linux/+bug/591707/comments/24

The reporter says that it also fails with 2.6.34. The report has logs showing that it works with 2.6.32 and fails with 2.6.35-rc1. I've requested the reporter install a vanilla -rc2 kernel from http://kernel.ubuntu.com/~kernel-ppa/mainline/v2.6.35-rc2-maverick/linux-image-2.6.35-020635rc2-generic_2.6.35-020635rc2_amd64.deb, but I do not expect different results given that the only change from rc1 to rc2 is 'e1000e: change logical negate to bitwise' (which is not germane to probing).

This appears to be an Intel OEM MB as far as I can tell from the DMI. It was new in April so is unlikely to have flash corruption issues such as those observed with 2.6.24.

Any suggestions on why the probe silently fails? None of the module params look like they'll make a difference.

rtg

Signature · 1 line
Tim Gardner [email protected]
#1 lore raw

Tim,

Quoted 2 lines
[   28.193628] e1000e 0000:00:19.0: PCI INT A disabled
[   28.193740] e1000e: probe of 0000:00:19.0 failed with error -3

This looks like a BIOS problem. It looks the interrupts aren't being setup correctly in the system and the driver can't request them. Why it's working on some kernels and not others may be do to some BIOS setup with the interrupts that happens in one and not in the other. Does the MB have the latest BIOS on it? Please make sure and test it again if not.

Cheers,
John