Initial MMU too low
Hello,
When I build a kernel with DEBUG_LOCK_ALLOC set, I get a kernel which has __bss_stop above the C0800000 limit, and then I get a bad page exception during the zeroize of the __bss at startup, because the initial MMU only maps the first 8Mbytes.
What can I do to fix that ?
Regards
C. Leroy
Quoted 8 lines · LEROY christophe
Hello,
When I build a kernel with
DEBUG_LOCK_ALLOCset, I get a kernel which has__bss_stopabove the C0800000 limit, and then I get a bad page exception during the zeroize of the__bssat startup, because the initial MMU only maps the first 8Mbytes.What can I do to fix that ?
Not much... maybe pin more initial TLBs ?
Ben.
Quoted 8 lines · On Sat, 30 Oct 2010 13:52:24 +0200 LEROY christophe <[email protected]>…
Hello,
When I build a kernel with
DEBUG_LOCK_ALLOCset, I get a kernel which has__bss_stopabove the C0800000 limit, and then I get a bad page exception during the zeroize of the__bssat startup, because the initial MMU only maps the first 8Mbytes.What can I do to fix that ?
Under "Advanced setup", select "Pinned Kernel TLBs". Ignore the "860 ONLY", it applies to all 8xx.
-Scott