Skip to contentSkip to conversation

MPC8377: SerDes config

U-Boot Andre Schwarz 1 participant 1 message Nov 5, 2010

lore
Share & tools
lore
#0 lore raw

All,

I'm a little confused how to setup SerDes properly on MPC8377, i.e. which function uses which port ...

I'd expect the following :

- SATA Ports 1+2 used on SerDes 1
- PCIe Ports 3+4 (2 times x1) on SerDes 2

This is what I've done :

CONFIG_SYS_SCCR_PCIEXP1CM = 0 (disabled) CONFIG_SYS_SCCR_PCIEXP2CM = 2 CONFIG_SYS_SCCR_SATACM = 0xA0 (Port 1+2 used / 3+4 disabled)

Still both SerDes are active :

#define CONFIG_FSL_SERDES
#define CONFIG_FSL_SERDES1 0xe3000
#define CONFIG_FSL_SERDES2 0xe3100

PCIe only gets one LAW @ CONFIG_SYS_PCIE2_BASE

Board init code calls

     fsl_setup_serdes(CONFIG_FSL_SERDES1, FSL_SERDES_PROTO_SATA,
                    FSL_SERDES_CLK_100, FSL_SERDES_VDD_1V);
     fsl_setup_serdes(CONFIG_FSL_SERDES2, FSL_SERDES_PROTO_PEX,
                    FSL_SERDES_CLK_100, FSL_SERDES_VDD_1V)

Is this supposed to be correct or have I swapped something ? Is it save to disable PEX-1 ?

Signature · 8 lines
Regards,
Andre



MATRIX VISION GmbH, Talstrasse 16, DE-71570 Oppenweiler
Registergericht: Amtsgericht Stuttgart, HRB 271090
Geschaeftsfuehrer: Gerhard Thullner, Werner Armingeon, Uwe Furtner