ACPI+Inspiron 1545 = crash at xrstor_state()
I previously reported a boot hang on an Inspiron 1545 laptop which is cured by disabling CONFIG_ACPI. I didn't know about the "earlyprintk" boot option, and upon using it, I was able to see the actual crash. Hopefully the following information will help. Note that I have turned off SMP and APIC/LAPIC support, but the bug persists even with these disabled (I noticed a lot of APIC/IO-APIC code that is eliminated in early boot if they're disabled.)
The crash was in function xsave_init with EIP at xstate_enable_boot_cpu (the last normal message output before this was "Initializing CPU#0"). To narrow this down further, I edited xsave.c to be full of printk() messages for each called function. The last printk message indicates that the function in xsave.c which crashes out is:
xrstor_state(init_xstate_buf, -1);
The result is a general protection fault. xrstor_state is just a tiny piece of asm code, and at this point I've reached the extent of my current capabilities, so I don't know where to go from here. I can manually type out chunks of the crash info on request. I'm clueless as to how the inclusion of ACPI causes this.
Please CC my email if you respond since I don't subscribe to LKML. Thanks in advance.
Jody Bruchon
Quoted 17 lines · Jody Bruchon
I previously reported a boot hang on an Inspiron 1545 laptop which is cured by disabling
CONFIG_ACPI. I didn't know about the "earlyprintk" boot option, and upon using it, I was able to see the actual crash. Hopefully the following information will help. Note that I have turned off SMP and APIC/LAPIC support, but the bug persists even with these disabled (I noticed a lot of APIC/IO-APIC code that is eliminated in early boot if they're disabled.)The crash was in function
xsave_initwith EIP atxstate_enable_boot_cpu(the last normal message output before this was "Initializing CPU#0"). To narrow this down further, I editedxsave.cto be full ofprintk()messages for each called function. The last printk message indicates that the function inxsave.cwhich crashes out is:
xrstor_state(init_xstate_buf, -1);
Quoted 8 lines
The result is a general protection fault.
xrstor_stateis just a tiny piece of asm code, and at this point I've reached the extent of my current capabilities, so I don't know where to go from here. I can manually type out chunks of the crash info on request. I'm clueless as to how the inclusion of ACPI causes this.Please CC my email if you respond since I don't subscribe to LKML. Thanks in advance.
Ok, first of all, which kernel are you using? Second, send us your .config. Then, please try booting the latest kernel (2.6.36) without your printk's in it and with earlyprintk enabled on the kernel cmd line and when the oops appears on the screen try to photograph it with a digicam or similar and upload the pic somewhere. Before that, make sure the pic is readable.
Thanks.
Signature · 2 lines
Regards/Gruss,
Boris.