Skip to contentSkip to conversation

GPIO on VIA Epia

DISCUSSION Udo van den Heuvel 1 participant 1 message Dec 30, 2010

lore
Share & tools
lore
#0 lore raw

Hello,

Did anyone do some work on a driver to use the GPIO pins on the VIA Epia boards based around the vt8237 or CX700?
E.g. my Epia LT offers 8 programamble GPIO pins according to the documentation (see below for layout) but I'd like to know if there is a driver so I can actually use them and e.g. receive an interrupt when a GPIO goes high or low.
Please let us know what is available.

Thanks,
Udo

Epia LT documentation:

Digital I/O Connector: DIO
General purpose input and output for POS systems.

 Pin     Signal               Pin     Signal
 1       5V_DIO               2       12V_DIO
 3       GPO_21               4       GPI_44
 5       GPO_22               6       GPI_45
 7       GPO_32               8       GPI_46
 9       GPO_33               10      GPI_47
 11      GND                  12      GND