ARM STM/i.MX: Add possibility to select the data mode for stm video driver ( DCn signal is high )
Subsystems (4)
PATCH 3/4 ARM STM/i.MX: Add possibility to select the data mode for stm video driver ( DCn signal is high )
At reset command mode of STM video controller is in command mode (DCn signal is Low). This commit allow to use the data mode (DCn signal is High). See explanations about bit 16 in HW_LCDIF_CTRL B in datasheet.
Signed-off-by Gregory CLEMENT <[email protected]>
--- arch/arm/mach-stm/include/mach/fb.h | 1 + drivers/video/stm.c | 4 ++++ 2 files changed, 5 insertions(+), 0 deletions(-)
arch/arm/mach-stm/include/mach/fb.h +1 -0
@@ -37,6 +37,7 @@ struct imx_fb_videomode {unsigned dotclk_delay;/**< refer manual HW_LCDIF_VDCTRL4 register */ unsigned ld_intf_width;/**< refer STMLCDIF_* macros */ +unsigned data_mode;u32 bits_per_pixel; };
drivers/video/stm.c +4 -0
@@ -399,6 +399,10 @@ static int stmfb_activate_var(struct fb_info *fb_info) fb_info->bits_per_pixel);return -EINVAL ; } + +if (pdata->data_mode) + reg |=CTRL_DATA_SELECT ; +writel (reg, fbi->base +HW_LCDIF_CTRL );pr_debug ("Setting up CTRL to %08X\n" , reg);
Signature · 9 lines
1.7.0.4 _______________________________________________ barebox mailing list [email protected] http://lists.infradead.org/mailman/listinfo/barebox