Verify-after-write on sub-pages
I am working on a project that requires high reliability of logged data which is written to a UBI file system on NAND. I have observed one hardware failure mode at elevated temperatures where some chips report that a write was successful even though a subsequent read indicates that this was not true. To mitigate this I enabled CONFIG_MTD_NAND_VERIFY_WRITE. Unfortunately I found this does not work on sub-pages which are used by UBI. As a workaround I have forced UBI not to use sub-pages, but I was curious if either there were plans to add this feature, or if anyone was working on implementing it?
Regards,
Dave.
Quoted 9 lines · David Lambert
I am working on a project that requires high reliability of logged data which is written to a UBI file system on NAND. I have observed one hardware failure mode at elevated temperatures where some chips report that a write was successful even though a subsequent read indicates that this was not true. To mitigate this I enabled
CONFIG_MTD_NAND_VERIFY_WRITE. Unfortunately I found this does not work on sub-pages which are used by UBI. As a workaround I have forced UBI not to use sub-pages, but I was curious if either there were plans to add this feature, or if anyone was working on implementing it?
Yes, CONFIG_MTD_NAND_VERIFY_WRITE is broken sub-pages for very long time. I doubt anyone is fixing this, you have a chance to do this :-)
Signature · 2 lines
Best Regards, Artem Bityutskiy (Артём Битюцкий)