Could not enter target state in pm_suspend in Overo board.

Hi,

I am testing pm in overo board. it is a freshly build kernel from OMAP mainline git.

From the below log, I have doubt whether the OMAP really goes into suspend to RAM state.

root@overo:~# echo mem > /sys/power/state
[  866.503662] PM: Syncing filesystems ... done.
[  866.590515] Freezing user space processes ... (elapsed 0.02 seconds) done.
[  866.620361] Freezing remaining freezable tasks ... (elapsed 0.04 seconds) done.
[  866.676452] Suspending console(s) (use no_console_suspend to debug)
[  866.807464] PM: suspend of devices complete after 119.415 msecs
[  866.810516] PM: late suspend of devices complete after 2.990 msecs
[  866.811279] omap_device: omap_uart.2: new worst case deactivate latency 0: 122070
[  868.480895] Powerdomain (core_pwrdm) didn't enter target state 1
[  868.480926] Could not enter target state in pm_suspend
[  868.482574] PM: early resume of devices complete after 1.464 msecs
[  868.734558] mmc1: error -110 during resume (card was removed?)
[  868.739562] PM: resume of devices complete after 256.439 msecs
[  868.796142] Restarting tasks ... done.

Queries.

[  866.811279] omap_device: omap_uart.2: new worst case deactivate latency 0: 122070

1 . do I need to set some thing before suspend to ram.

[  868.480895] Powerdomain (core_pwrdm) didn't enter target state 1
[  868.480926] Could not enter target state in pm_suspend

2. So it didn't enter into the suspend state completely .

Could some one clarify the above.

Best Regards,
Mohamed Thalib H