Skip to contentSkip to conversation

How to establish a priority to an interrupt handler

DISCUSSION Monica Puig-Pey 2 participants 2 messages May 16, 2011

lore
Share & tools
lore
#0 lore raw

Hi,

I'm using Ubuntu 10.04 with the 2.6.31-11-rt patch installed. I'm developing a PCI device driver using hardware interrupts.
As I read at the RT wiki (https://rt.wiki.kernel.org/index.php/CONFIG_PREEMPT_RT_Patch ) interrupts are moved to kernel threads called Threaded Interrupts in the RT patch.

I would like to give a priority chosen by me to my IRQ handler, but I don't know how to do it, or if it is possible (it seems it is).

I've found (http://lwn.net/Articles/302043/ ) that what I had to use in order to get Threaded Interrupt is:

int request_threaded_irq(unsigned int irq, irq_handler_t handler,
irq_handler_t quick_check_handler, unsigned long flags, const char *name, void *dev)

But there is not priority there!

Using ps -eo pid,pri,rtprio,cmd I've seen my handler runs with priority 50.

I also used :

int request_irq (unsigned int irq, void (*handler) (int, void *, struct pt_regs *), unsigned long irqflags, const char *devname, void *dev_id);

and using ps command here my handler still runs with priority 50. Shouldn't it work as a non threaded interrupt then? Why 50 instead 99 or the highest priority one?

Which function should I use to chose the priority for the IRQ thread?

Is there any other function to call from this context where my handler could know its priority?

Thank you

Mónica
--
To unsubscribe from this list: send the line "unsubscribe linux-rt-users" in the body of a message to [email protected]
More majordomo info at http://vger.kernel.org/majordomo-info.html

#1 lore raw
Quoted 11 lines · Monica Puig-Pey

Hi,

I'm using Ubuntu 10.04 with the 2.6.31-11-rt patch installed. I'm developing a PCI device driver using hardware interrupts. As I read at the RT wiki
(https://rt.wiki.kernel.org/index.php/CONFIG_PREEMPT_RT_Patch ) interrupts are moved to kernel threads called Threaded Interrupts in the RT patch.

I would like to give a priority chosen by me to my IRQ handler, but I don't know how to do it, or if it is possible (it seems it is).

This may not answer your question, but

apt-get install rtirq-init

might be all you need to do in order to get the interrupt priorities set and sorted out for your purposes (well, for sound recording/processing/playback it usually works reasonably well).

Even if not, taking a look at what the rtirq service script does might give you good ideas.

Signature · 1 line
David Kastrup