pthread_create/10-1: correct return value if test fails

This patch fixes return value always being 0 even if test fails. Using _exit(value) instead of pthread_exit();.

Signed-off-by Peng Haitao <[email protected]>

---
 .../conformance/interfaces/pthread_create/10-1.c   |    8 ++++----
 1 files changed, 4 insertions(+), 4 deletions(-)

testcases/open_posix_testsuite/conformance/interfaces/pthread_create/10-1.c +3 -3

index 265901f..fe0c88d 100644
@@ -76,16 +76,16 @@ void sig_handler(int sig)
 		if (created_thread == 1)
 		{
 			printf("Test FAILED: Created thread though an invalid attribute was passed to pthread_create().\n");
-			pthread_exit((void*)PTS_FAIL);
+			_exit(PTS_FAIL);
 		}
 
 		printf("Test PASSED\n");
-		pthread_exit((void*)PTS_PASS);
+		_exit(PTS_PASS);
 		return;
 	}
 
 	printf("Test FAILED: Did not receive segmentation fault signal, waited 10 seconds.\n");
-	pthread_exit((void*)PTS_FAIL);
+	_exit(PTS_FAIL);
 	return;
 }