Skip to contentSkip to conversation

Beagleboard SPI

DISCUSSION Jack Mitchell 1 participant 1 message Sep 20, 2011

lore
Share & tools
lore
#0 lore raw

A quick shout out to see if anybody has any experience with setting up SPI on a BeagleBoard xM Rev C. I have applied patches as stated in the eLinux wiki to no avail. Patches are listed below:

I am running kernel 2.6.37 and u-boot 2011.06 and have applied the following patches:

u-boot for pin muxing:
http://pastebin.archlinux.fr/434099 <http://www.google.com/url?sa=D&q=http://pastebin.archlinux.fr/434099&usg=AFQjCNFRHAJ90b8iCdCTPiFhHQZDBdSK2g>

kernel for spidev config and loading of the driver:
http://pastebin.archlinux.fr/434100 <http://www.google.com/url?sa=D&q=http://pastebin.archlinux.fr/434100&usg=AFQjCNEd7TramfvbJWPN0AfrrgCg07lkIQ>

http://pastebin.archlinux.fr/434101 <http://www.google.com/url?sa=D&q=http://pastebin.archlinux.fr/434101&usg=AFQjCNHX768E4py5Y1_k1U0BwiSNQBQIBg>

SPI shows up in /sys but there is no node created in /dev.

If anyone can see any faults or have any suggestions I would love to hear them as i'm coming close to bald!

I also have a post listed on the BeagleBoard Google Board:
http://groups.google.com/group/beagleboard/browse_thread/thread/273a51d0ff91537d

Kind Regards,
Jack.