U-Boot not auto booting
Quoted 13 lines · Michael Aldridge
the autobooting function of uboot is not functioning properly on my sheevaplug with debian.
I have set the bootcmd and bootdelay variables, but I still can't get it to work. I can watch the countdown hit zero, and I do not hit any buttons and then the whole process just stops at the prompt.
If I disconnect the serial cable from the computer, it still fails to proceed with the boot process.
Below is the dump of 'printenv' any suggestions?
Quoted 9 lines
Marvell>> printenv
autostart=yes
baudrate=115200
bootargs=console=ttyS0,115200 bootargs_console=console=ttyS0,115200
bootcmd=setenv bootargs $(bootargs_console); runbootcmd_mmc; bootm0x008000000x01100000
bootcmd_mmc=mmc init; ext2load mmc 0:10x00800000/uImage; ext2load mmc 0:10x01100000/uInitrd
Can you load your uImage and uInitrd from the mmc? What version of uboot are you running? Nowadays 'mmc init' is 'mmc rescan'.
Try to type the commands individually:
$ mmc rescan $ ext2load mmc 0:1 0x.... /uImage $ ext2load mmc 0:1 0x.... /uInitrd $ bootm
and see where it stops working.
Helmut
--
Scanned by MailScanner.