Skip to contentSkip to conversation

ASoC: Add support for TI LM49453 Audio codec

PATCH M R Swami Reddy 1 participant 1 message Feb 6, 2012

lore
Share & tools
lore
#0 lore raw

Mark Brown Wrote:

Quoted 8 lines
Quoted 5 lines

---
Changes made in V2
o Removed fll and vco reference frequency settings from _set_dai_pll()
o Reworked chip enable and disable in _STANDBY and _OFF modes in m49453_set_bias_level, as per the review comments.

You say this is version 2 but there's been rather more than two versions posted...

Thats right. I started numbering the patch version with previous one, so mentioned it as v2. The version number will be continued.

Quoted 5 lines

Review

Quoted 3 lines
(quoted diff) +3 -0
+static int lm49453_set_dai_pll(struct snd_soc_dai *codec_dai, int pll_id,
+                              int source, unsigned int freq_in,
+                              unsigned int freq_out) {

This is now a bit odd.

I will update it as per the other drivers formate.

Quoted 5 lines

Review

Quoted 2 lines
(quoted diff) +2 -0
+       state->in = freq_in;
+       state->out = freq_out;

It stores but otherwise ignores the configuration which was passed in (which seems more than a little odd).

Will be removed in the next patch.

Quoted 10 lines
Quoted 10 lines
(quoted diff) +10 -0
+       /* Always disable the PLL - it is not safe to leave it running
+        * while reprogramming it.
+        */
+       snd_soc_update_bits(codec, LM49453_P0_PMC_SETUP_REG,
+                           LM49453_PMC_SETUP_PLL_EN, 0);
+
+       if (!freq_in || !freq_out)
+               return 0;
+
+
Quoted 8 lines

Review

Quoted 3 lines
(quoted diff) +3 -0
+       /* All done, turn it on */
+       snd_soc_update_bits(codec, LM49453_P0_PMC_SETUP_REG, pwr_mask,
+                           pwr_mask);

Then if the PLL was already enabled it bounces the power briefly. Really it seems like this should just be merged in with set_sysclk() - you're not actually configuring the PLL at all, just turning it on and off, at which point it's just another SYSCLK source.

Ok. The PLL disable code will be removed and the PLL enable code will be moved to _sysclk().

Quoted 1 line

Otherwise this seems good, just this clock configuration stuff to sort out.

OK. Thank you. Do I need to resend the patch.

Thanks
Swami