Skip to contentSkip to conversation

Booting Beagle over NFS

DISCUSSION Jack Mitchell 1 participant 1 message Feb 6, 2012

lore
Share & tools
lore
#0 lore raw

Hello everyone,

I am attempting to boot my BeagleBoard over NFS. Now I have followed some instructions and used my onw knowledge to derive the boot parameters as shown here:

Quoted 2 lines

setenv bootargs 'console=ttySO2,115200n8 noinitrd rw ip=10.0.11.2::255.255.255.0 root=/dev/nfs nfsroot=10.0.11.1:/home/jack/yocto/poky-edison/beagleEdison/beagleRootFS,nolock,rsize=1024,wsize=1024,rootdelay=2' setenv bootcmd 'mmcinit;fatload mmc 0 80300000 uImage;bootm 80300000'

I am then making an image file as show here: http://www.yoctoproject.org/download/bsp/texas-instruments-arm-cortex-a8-development-board-beagleboard-0

Quoted 2 lines

mkimage -A arm -O linux -T script -C none -a 0 -e 0 -n "Core Minimal" -d ./serial-boot.cmd ./boot.scr

I then proceed to boot my beagle and it just uses the old settings where it reads the root from the mmc. I have also tried copying the boot commands to the boot partition with the name uEnv.txt, still to no avail.

Does anyone have any clues why it is not picking up my new boot configuration?

It would also be useful to turn of quiet booting on the Beagle, does anyone know how this is done, I cannot see any initialisation of the kernel over serial.

Best Regards,
Jack.