Cannot compile media_build from git sources

Bogus,

This is the same problem I wrote about on March 21, 2012. I have received no reply so far.

You can try to work around the problem as I did:
-- This assumes you don't need radio-rtrack2.
-- Look at the build command. Near the end are two "make" commands. Comment out the last one.
-- Run the resulting "build". Then go into ../media_build/v4l/.config Set the "radio-rtrack2" to "n" (from "m"). -- Then go back to the directory which has the "build" program and just run "make" ...... if all runs OK, then run "make install."

Good luck!

Joe Henley